Konica Minolta bizhub - Recent Questions, Troubleshooting & Support - Page 8

Power error switch machine of pressed STOP ? KEY THEN ON MACHINE ERROR CLEAR AUTOMATIC

Check your toner bottle if is ok then contact service representative may be problem is thermometer

Your paper size is different from computer setting go to device and printer click your bizhub 215 click printer preference click back click paper size ser A4 then ok and print

check The Transfer Belt or it can be the Black Image Unit . (P9 & P21 normally: black Imaging unit) but P21 can also be refered to Transfer Belt). ..

was told this message meant Konica have disabled the machine remotely.

What is the touch display error message?

No,the transfer belt unit resetting automatically.

Verify and clean the paper passage rollers and inspect the actuator.

Check and clean the paper passage rollers (pick-up,feed and separation rollers).Clean the paper transmision roleers located before drum unit.

machine trouble sevice call [c2558] wat a problam in konica minolta bizhub 164 printer

1102 is output tray lift motor did it hit something on the way down? 2801 replace the drum and developer

Power off the machine. Then remove the toner bottle, be careful the hole might be on the bottom and the toner is going to go everywhere. Then close the toner cover and turn on the machine. Let the machine go through it normal routine. When it asks for toner install the toner bottle correctly. If THE KNUB on the side of the bottle is damage put a new one in. That KNUB is what the toner motor uses to turn the bottle, if it damaged you get a code. If that does not work, you might have a bad motor or the home sensor or actuator for the toner bottle is bad worse case the control board is bad

FS-523 Finisher lift motor of the where the copies or prints come out the lift motor is shot!! or its not turning to lift the motor did the tray hit something on the way down or up???

replace the drum and developer and run TCR and gradation adj

First replace the drum and developer

Under, Admin setting/User Box settings/External Memory Function settings/ Turn on scan to.

Replace the yellow drum and developer unit

Did the machine state to replace the drum and developing unit are they OEM or third party? Did you run gradation?

Go to the control panel under paper select bypass tray set to A4 or 81/2x11 select weight and the go to computer select bypass tray and paper weight

Check tray 2 paper draw and see if there is paper behind it.