KitchenAid Cooktops - Answered Questions & Fixed Issues

Wish to purchase kitchen appliances then http://where-to-buy.in is your best choice where you can purchase any kitchen appliances along with great offers.It is the best corner where you can enjoy a wide range of products like computers,books,mobile phones and lots.

In this video You can see how to replace any component on kitchenaid cooktops! I hope it helps. Thanks! How To Repair Whirlpool KitchenAid Stove Cooktop HD 1080

Mis-wired or the new control panel is faulty. Call them back, it is under repair warranty. The parts aren't cheap! https://www.searspartsdirect.com/model/41v4g0ja62-000593/kitchenaid-kecc667bbl01-electric-cooktop-parts ..

igniter failed

Almost certainly the switch, not the element, Had the same problem on a different stove - went to 10 no matter what the knob was set to. Here is a parts list, you should be able to get the part from a local appliance part seller. I used ReliableParts in my town. https://www.partselect.com/ModelSections.aspx?ModelID=815598&ModelNum=KECD805HBL3&mfgModelNum=&ManufactureID=3&Selected=ZPGZLZRB&Position=2&mfg=Whirlpool&Type=Cooktop&Mark=2

I found this...... https://www.doityourself.com/stry/how-to-replace-a-glass-cooktop-on-kitchenaid-ranges I read it and it's on replacing but the top comes out. Gloves are a good idea too. Cut power at the breaker. unless easy access to the wiring/plug. Hope this helps you. Have a good evening.

Kitchenaid KSC24C8EYY02 Manuals

www.manualslib.com > Brands > KITCHENAID Manuals > Refrigerator Kitchenaid KSC24C8EYY02 Pdf User Manuals. View online or download Kitchenaid KSC24C8EYY02 Installation Instructions Manual, User Instructions.

You should make sure the range matches the correct gas, if you have to change orifice you must get the correct ones from manufacture do not use any other orifice always unplug electricity before attempting to repair on any electrical appliance

It is likely the computer in the control board I have seen this many times. It is really hard to get the factory to think this cause it's new and it is expensive. But you have checked the power so there is not much more that it could be

I don't have a Thermador cooktop but here is ma taught. Could you unplug the two faulty igniters and see if problem remained Could you plug one of the faulty igniter at the location of a good one. The goal is to isolate the problem. Is it the igniter or the electronic board. Faulty ground problem may occur also after an spillover on the stove. In that case, use a cotton swab dipped in scrubbing alcool and clean the spark area on the igniter and the burner. Good luck

How to Install Cooktop

They go under the counter and they are screwed in place

Hi, Need model number of your range to answer this question. Is this gas or electric? Is this a freestanding range or cooktop because I only can find information on ranges with this fault code given. All should EEPROM communication error which is a communication error on start up. when the top was damaged was the unit being used? Was water or liquid a factor when this damage happened? A loose wire would be a different error code or fault code like a F2 - E1 or E2, not your code given. I hope this helps, need more information. Thanks I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

Call the repair company to come back. It's possible he didn't hook something up right. ...

To Unlock Cooktop: Touch and hold the CONTROL LOCK/ ALL OFF keypad for 5 seconds.

If it does it with each individual burner 'ON', it may be something in the gas line.

changing everything on this kitchenaid cooktop video

full repair of kitchenaid cooktop in one video. spark module, switches, igniters and jets replace.

The seal on the door is not making contact with the fridge. Take a hair dryer on moderate heat setting close the door and heat up the seal where the frost is until it gets flexible and makes contact with the fridge for a good seal. Should happen in about 30-45 seconds. I had the same problem, waited around all day for a service tech to come and he did this in a minute. I was not happy and was like why did you not just tell me to do that over the phone.

Everything about It.. Thanks for watching