2020 kia Sorento 2.4 liter
Clicking sound on the driver side when turning
possible reasons for this issue:
CV Joint Issues: The clicking sound during turns could be related to the constant velocity (CV) joints. These joints allow the wheels to transfer power from the transmission to the wheels while maintaining flexibility during steering. If a CV joint is worn or damaged, it can produce clicking sounds. Inspect the CV joints for any signs of wear, such as torn boots or visible damage.
Wheel Bearing Problems: Faulty wheel bearings can also cause clicking noises during turns. A worn-out wheel bearing may produce a clicking or grinding sound. Check for any play or looseness in the wheel when jacked up. If you notice excessive play, it's likely that the wheel bearing needs replacement.
Suspension Components: Inspect the suspension components on the driver's side. Loose or worn-out components, such as control arms, bushings, or sway bar links, can create clicking sounds when the vehicle turns.
Steering System: Check the steering system components, including the tie rods, steering knuckles, and steering column. Damaged or worn parts can lead to clicking noises during turns.
Brake Caliper Issues: Sometimes, a loose brake caliper or worn brake pads can cause clicking sounds. Ensure that the brake caliper bolts are properly tightened and that the brake pads are in good condition.
Axle Shaft: The axle shaft connects the transmission to the wheels. If there's damage or wear on the axle shaft, it can result in clicking noises. Inspect the axle shaft for any signs of damage.
Here are some steps you can take to diagnose and address the issue:
Visual Inspection: Jack up the vehicle again and inspect the components mentioned above. Look for any visible damage, loose parts, or signs of wear.
Test Drive: Take the car for a test drive and pay attention to when the clicking sound occurs. Does it happen during slow turns, sharp turns, or both? This information can help narrow down the cause.
Professional Inspection: If you're unable to identify the issue, consider taking the vehicle to a qualified mechanic. They can perform a thorough inspection, diagnose the problem.