Kenmore Washing Machines - Popular Questions, Answers, Tips & Manuals


Sounds like the wiring to the element and a bad connection. Pull the machine out and lean it up against the wall. Make sure it is leaning well and won't tip forward. Look up underneath with a flashlight.

Kenmore Washing... | 35 views | 0 helpful votes


Hello. There are several things that can cause this problem. The first thing I check is the drain pump--if there is 120 volts getting to the pump, and the pump is not running, the drain pump is either jammed or the motor is bad. If there is NOT 120 volts at the pump when it should be running, that indicates either a broken wire from the main control board or, a defective main control board. If the unit senses water in the tub, IT WON'T SPIN. One of the other causes of a no-spin could be a defective lid lock or even a corrupted/damaged main control board. The drive motor for the unit is controlled by the main control board which is told what to do by a program. If you have power outages, the board could have been partially damaged by a current surge when the power was restored. (Outages are NOTORIOUS for damaging circuit boards in appliances). If it wasn't blown out immediately, USUALLY about 4-6 weeks after the event the chips on the boards start to fail causing varied problems.

Kenmore Washing... | 33 views | 0 helpful votes


On newer washing machines,built within the last 10 years,you cannot bypass the lid lock. This is all monitored by the main control. Its not like the old days where you could jump out a switch. Modern machines just will not work due to heightened safety features due to the high rpms at which they spin

Kenmore Washing... | 33 views | 0 helpful votes


Go to www.repairclinic.com and enter 110.42722201. With luck, you will be presented with a list of repair parts/assemblies and may be able to view a generic Kenmore video showing disassembly.

Kenmore Washing... | 54 views | 0 helpful votes


Probably not. That's one of the design weaknesses of Kenmore (and other) washers.

Kenmore Washing... | 59 views | 0 helpful votes


Hold down lock button for 10 seconds

Kenmore Washing... | 61 views | 0 helpful votes


Could be cycle timer failure

Kenmore Washing... | 34 views | 0 helpful votes


The door lock may be damaged or defective.

Kenmore Washing... | 45 views | 0 helpful votes


Probably a worn-out bearing; try rocking the empty drum by hand within the tub. If it is loose on the hub, discontinue use to avoid further serious damage, and get a service engineer to take a look.

Kenmore Washing... | 150 views | 1 helpful votes

Not finding what you are looking for?
Kenmore Logo

Family Lines

31,000 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

fordexpert

Level 3 Expert

5692 Answers

Harvey Mahal

Level 2 Expert

39 Answers

Kristen Denison
Kristen Denison

Level 1 Expert

13 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...