Kenmore Ovens - Page 2 - Recent Questions, Troubleshooting & Support

Sounds like a faulty thermostat. Google make model parts diagram

If it is giving an overheat alarm, I would have replaced the sensor anyway. If you have been using the self cleaning feature of the oven, it may be that, that burned the board. https://www.google.com/search?q=kenmore+convection+oven+f10+error ..

What is the exact model number of that unit and have you looked to see if there is a technicians sheet attached to the back of it?

Probably the pilot light feed is blocked. Clean the jets.

Due to the cost of control boards and the problems associated with them, I always advise a service call to replace them. In that way the part and the service provided is warrantied. They keep going until it is fixed. Request to send the board back as faulty and ask them to double check it is the correct board for your service and sub-model. There are 6 sub-models designated by another 4 numbers after the '9420'. https://www.searspartsdirect.com/model/1k9fnm0gf7-000582/kenmore-79094202310-parts ..

HI. follow the procedure below.

1. Disconnect power for at least 30 seconds.
2. Re-apply power and observe for at least one minute.
3. If code re-appears, replace control board (also called ERC or clock).

Hopefully someone answered your question by now. If not, the glass bulb cover sticks sometimes, but it does turn counterclockwise. Be firm with it, let it know who's boss. Once you've removed it, you can replace the 40 watt appliance bulb. (The manual suggests you unplug the range or disconnect power for your safety). Good luck.

Almost certainly a burned out element, so test with a multimeter after turning off the power. Could also be; Burned out connectors onto the element. Fuse if it has them. Switch control. (unlikely)

buy new is only fix there is

Question edited for clarity. You need a service call. It's dangerous. The F10 code on a Kenmore oven means that the oven is overheating - the oven is detecting a temperature far over the safe range of operation. Most models also start beeping when this happens since it can be a safety concern.Apr. 14, 2020

How to Troubleshoot Error F10 on a Kenmore Stove ' Hunker

https://www.hunker.com > ... > Other Home Appliances About featured snippets

How To Fix Frigidaire Range F10 Error Code (appliancecodes.com)

When you got home, the meal was destroyed? The latent heat will stay in the oven cavity for many hours if properly insulated around the cavity.

KENMORE C970 USE & CARE MANUAL Pdf Download ' ManualsLib Kenmore Range Stove Oven Troubleshooting & Repair ' Repair Clinic

no reset

if lower element tests open with continuity meter then it for sure is bad. i would also check the wire ends that connect to the element and/or the control board, they could have loosened allowing a bad connection and low voltage to elementor burnt off.. most ovens do not use the broil element at all during the bake cycle, only during the broil cycle.. some however do utilize the broil element during baking, but at a lower wattage or something..
best of luck,
ttfn

WWW.SEARSPARTSDIRECT.COM

defective thermostat possibly

Use a barbeque cleaner.

if voltage to ignitor or heating element replace

Could be temperature control failure