Kenmore Cooktops - Page 5 - Recent Questions, Troubleshooting & Support

Most likely the problem is in the heat control switch.Cannot be repaired you will have to replace it. To make sure, swap it with one of the other burners that do not have the problem. If the problem goes away, you know its the switch.

It is a security measure to remind you that the surface may still be hot.

You might take some close up photos of the range and send them to gas range parts suppliers to see if they can recognize it and give you the info you want. Maybe try: http://www.partselect.com/Entry.aspx?Source=GAWS&Term=Range+Parts&gclid=CP-hgZz41L8CFZRj7Aodqx0AIw Good luck Pete

CALL CUSTOMER SERVICE

it will not until door is closed tight , fix door and it should work see if any thing fouling door from closing properly .

Tempature probe(Temp sensor) on that burner is malfuncting . Replace that probe. www.searspartsdirect.com/partsdirect/brands/kenmore-parts

It probably has a flame failure device.. This is to cut off the gas if the flame goes out.. When you light the burner, the flame heats a sensor which keeps the gas on, if this is faulty, the gas will go out.

The clock runs on 110 volts and the oven at 220 volts. If the cook top is on, the issue is in the stove. Best left to a qualified technician. If the cooktop is also not functioning, check the breaker.

Make sure the clock is not set to "auto" function or on "timer" mode. The oven will not start until the correct time has come up. If the clock is not working , this is likely to be the problem. See if there is a manual operation control or switch. You may have to get a new clock or arrange for the clock to be bypassed so the oven can work without it. Most electronic clocks can stop an oven from working if they fail.

Replace the sensor probe, as that is what the code stands for.

Could be the lock needs replacing the oven won't self clean if the door lock isn't functioning it's a safety thing so you don't get your face burnt . Ray

Could be the thermostat has perished and should be replaced it's the skinny tube in the oven with a thin copper tube which runs back to the switch and is connected to the switch it all needs replacing.