Kenmore Freezers - Page 9 - Recent Questions, Troubleshooting & Support


THIS MAKES NO SENSE.

Kenmore 27.6 cu.... | Answered on May 18, 2015


Mine did the same thing two years ago. Sadly, no reset button... it just leaked the refrigerant out :(

Kenmore Freezers | Answered on May 14, 2015


Hello;



My name is Peter. I am a retired field service refrigeration technician.



The normal cycle is: Your compressor will turn on to raise the freezer temperature 20 degrees F. above the set temperature, and then the compressor will shut off, Until the freezer temperature drops 20 degrees F. below the set temperature and again the compressor will turn on.



One of the main problems with this type of freezer is the door gasket becomes crushed over time or the door is so thin it becomes deformed.



Do not try to replace the door gasket. You have to soak the new gasket in hot water for 1/2 hour and then form it on the door.



If you notice a gap in the corner of the door - pull hard on it to get it flush.



Recondition the door gasket - With a hair dryer and a kitchen spatula, heat the gasket and try to expand the gasket by pulling out with the spatula.



You can purchase a special freezer lubricant. Be sure not to over do it. It can make the door hard to open. P/N 542638

1/2 Oz. $12.00.

Kenmore Freezers | Answered on Apr 19, 2015


Of course there is. Go to the Sears support site and download it.

Kenmore Freezers | Answered on Mar 19, 2015


http://www.sears.com/kenmore-20-cu-ft-upright-freezer-white/p-04622042000P

Kenmore Freezers | Answered on Mar 15, 2015


need the entire model number from the tag on the unit

Kenmore Freezers | Answered on Mar 15, 2015


The defrost timer is faulty or you have a defrost circuit short, unplug remove back panel inside the freezer and check for a short in the heater and defrost thermostat.

Kenmore 13.7 cu.... | Answered on Mar 15, 2015


It may take some time for the icemaker to get the water after a filter change or there could be other problems

Kenmore Elite... | Answered on Mar 15, 2015


Its either a bad defrost timer not kicking on, bad main control board or the temp switch. Sorry not much help but the only way to really tell is check with a ohlm meteor and eliminate each part.

Kenmore 26.5 cu.... | Answered on Mar 04, 2015

Not finding what you are looking for?
Kenmore Logo

1,765 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Freezers Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Felizardo Erilla
Felizardo Erilla

Level 2 Expert

241 Answers

PNiss

Level 2 Expert

151 Answers

Are you a Kenmore Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...