Johnson Boating - Answered Questions & Fixed Issues

https://www.google.com/search?q=1957+johnson+outboard+10+hp+fuel+oil+ratio What is the mix ratio for a Johnson outboard motor? Any Johnson outboard motor built since 1964 requires a 50/1 fuel ratio. Motors built prior to that date require a 32/1 ratio, with the exception of a few fishing motors built prior to 1955 that use a 16/1 ratio. Feb. 22, 2021

What is the mixing ratio for a Johnson outboard motor? - Mvorganizing.org

marine shop---- online search

With the issue being in both up and down, You may have bent the tilt/trim shaft(s) .. this is a job for a professional!!! sorry..

Push button ignition switch. Push the key IN while starting it.

CALL YOUR LOCAL DEALER AND ASK THEM . i NEVER TRIED TO REMEMBER SUCH THINGS WHEN I HAD THE SERVICE MANUAL AT HAND

Check spark 1st, if ok check fuel line.

Service the carburetor. Check cooling system. it may clogged. Run it in a tub and monitor heat buildup. When it stops running, do you have ignition spark? If no then the ignition coil maybe shorted when hot or it may have moved due to untightened screws.

Check this thread on removing the tilt trim from your 1998 50hp Johnson motor: https://www.thehulltruth.com/boating-forum/490732-1998-johnson-50-hp-trim-tilt-repair.html

I don't know if this will be helpful, but I would check the compression and see if the rings are holding compression. If they are, that would indicate the cylinder should be drawing air in through the carb. If there is poor compression in the cylinder in question, that could mean that cylinder is not drawing in the air through the carb.

Do you have a question? If you are looking for the journalist Verity Johnson, start with her website http://www.verityjohnson.com/ or a Google search.

See this. At about 4 minutes, he shows where the bypass screw is located. The fuse could be an inline one and is probably located by the control switch for the tilt unit, but it may be located somewhere else, depends on who wired it up.

http://boatinfo.no/lib/evinrude/manuals/1992-2001johnsonevinrude.html Try this site hopefully it helps?

Great Work, It is a nice Post. It was very helpful for me. Thanks Keep it Up <a href="https://tutuapp.buzz/">Tutuapp</a> <a href="https://tutuapp.buzz/mobdro-apk-download/">Mobdro</a> <a href="https://tutuapp.buzz/whatsapp-dp-latest-images/">WhatsApp dp</a> <a href="https://tutuapp.buzz/instamp3-apk-download/">Instamp3</a> <a href="https://tutuapp.buzz/mobilism-apk-download/">Mobilism</a>

About 58 lbs.

ok so you have removed the propeller from the leg so now you need to get a spanner to fit the nut then turn the engine clockwise to undo the pinion gear

Hi ,check the needle and seat in the carburator it may not be not be cutting off the fuel when the carb is full as this can cause flooding into the throat of carb

This may help.

probably from the 90's

notify a marina in your area for assistance