Jet Air Tools & Compressors - Recent Questions, Troubleshooting & Support
Gun is stuck won’t release on jet wash
you don't give any real good information on this like model number what is stuck and what your trying to do. kind of like me asking my pen won't write on paper. what is wrong?
How do I clean my SATA Jet NR2000?
take apart the spray nozzle and needle and soak in laquer thinner overnight take a gun brush clean all parts and reassemble try spraying some clean thinner through it and check your pattern
Gun has very little sand coming out
The feed is plugging up either because of too large a piece of material (ie recycled sand) or moisture. Where i live, if I try to sandblast at less that 40 degrees f., even with dry sand, the temp makes my 50 foot hose cold, & sand does the same thing as your description. I also have a 80 lb unit that will do the same,
For the small ones that are not pressurized, (I have one that you just stick the end of the feed hose into the sand bag) my normal problem is if the sand is damp, since the sand is new. hope this helps, rick
I need a head valve seat for central pneumatic 21 degree angle framing nailer model 60828 also need headvalve seat for 34 degree angle finish nailer 68020
I have not been able to purchase replacement parts for these nail guns , however, have repaired them using parts from Bostitch framers and or just make the part. If the seal fits over the top of the cylinder, then try using seal from Bostitch framer part #N70155 fits a bit tight but works. Heat with a hair dryer to soften and install. If the seat is incorporated within the head valve, just dig it out and replace it with liquid two part urethane. Just mix and pour it in. After cleaning out the old seal, place head valve on level surface and pour in the mixed urethane till slightly over full to give the seal a nice crown. The finish nailer might also be repaired using other brand of seals. Remove the old part and take it to service center for a possible match. Good luck with your repair.
What oil should I use in Handiair H8/25 Compressor?
Many air compressors use a mineral blend or a synthetic oil, such as synthetic hydrocarbon, polyol ester or polyglycol. It is important to use a lubricant specifically rated for air compressors; do not use a general-purpose motor oil used for automotive or other purposes.
Read your user manual for more information.
Not finding what you are looking for?