Intex Pool & Spa - Page 6 - Recent Questions, Troubleshooting & Support
We have code E95 on intex spa when the heat is turn on Pump works but heater doesn't
This is a theoretical discussion only concerning Intex Error Code 95. "Water Too Hot" issue when it is not! My tub was still under warranty when it failed after 10 months of lite use. Intex sent me a new base but this is how I might have effected repairs on the old base.
One could bypass the normal digitally controlled heating process in favor of an analog process.
1. You would need to add a relay that is normally open to the recirculation pump leads. The type of relay depends on the voltage supplied to the recirculation pump motor. My motor appears to run on 12 volt AC so a 12 volt relay would be in order. Coil lines run to the pump power leads while the N/O circuit is wired to another, second, 120V AC 10 Amp dpst or dpdt relay. This relay ensures that the heating element only receives power when the recirculation pump is energized and that the heating element lines are isolated when not in use. Otherwise, the heating element could turn on and either boil the water or worse.
If you out of warranty and looking for a brand new energy efficient heater visit this site below
https://bluewaterspoolservices.com/best-pool-heater
Not finding what you are looking for?