Icon Exercise & Fitness - Answered Questions & Fixed Issues

1) Try to get out the controller board motor, and put In bag dry Rice, by 48 hours. 2) clean the board with special contacts cleaner or board electronic( you can buy from any electronic store). 3) Put again the board in the treadmill, If work is ok, IF not the components like IGBT is fault, Replace the completely board. Blessing [email protected] cell+whatsAPP:+50588611441

WHat is the brand and model #?

yes you do since you uninstalled it

find the manual here

To force a sync on your computer, right click the Fitbit Connect icon (fitbit icon located next to the time) and then click "Sync Now".

Hello there, It seems that you have a stuck button or a problem with the ifit card area. Yes I know you probably dont use it but just listen. If you have the demo card for the unit try putting the demo card into the ifit slot and press it in and out a couple of times. This will sometimes correct this problem. If that does not correct it then you will need to replace the console or possibly disconnect the ifit section from the console itself. Either way you will need to remove the console.
If more info is needed please leave me a note here and I will get back to you asap.
Good Luck! Tim

you can use eny magnet, and if you need the string you can epoxy glue it to the magnet you are using

If you wish to get some details; check the site linked here. Pull up older posts treadmill . Surf the site with patience. http://electro-medical.blogspot.com/

If you wish to get some details; check the site linked here. Pull up older posts for treadmill . Surf the site with patience. http://electro-medical.blogspot.com/

It's likely your call display

check the motor controler board

there is a short in the main drive motor If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

There is a power switch on the back of treadmill. Flip switch.

Press stop

This may well be either the Console LCB Post wire

You may need a new LCB.

Does the console count down ? If so and belt wont move then you have a problem with the LCB.

This error code is usually associated with a faulty incline motor.

There is a number of reasons, Faulty console Faulty wire lume Faulty LCB These reasons will only be if you have power to the machine.

Hi There, This is in need of a new console. This is the only way to fix the problem.