1) Try to get out the controller board motor, and put In bag dry Rice, by 48 hours.
2) clean the board with special contacts cleaner or board electronic( you can buy from any electronic store).
3) Put again the board in the treadmill, If work is ok, IF not the components like IGBT is fault, Replace the completely board.
Blessing
[email protected]
cell+whatsAPP:+50588611441
If you wish to get some details; check the site linked here. Pull up older posts treadmill . Surf the site with patience.
http://electro-medical.blogspot.com/
If you wish to get some details; check the site linked here. Pull up older posts for treadmill . Surf the site with patience.
http://electro-medical.blogspot.com/
Run the software calibration for easy diagnostic and fix it. Lube the incline mechanism. Go to Hood cover motor and follow the steps or read your owner manual.God bless you
1) test the terminal motor with VOM, if there are Voltage the motor is faulty.2) test the output voltage coming from control board, if there are Not voltage for to input voltage motor, the board is faulty.replaceGod bless you
see the video and proceed according. Lube the rollers bearing front+back with silicon or wax( depend of your mark, model) read your owner manual.God bless you