Hyundai Heating & Cooling - Recent Questions, Troubleshooting & Support
E6 fault code Hyundai air conditioner
The E6 error code on a Hyundai air conditioner typically indicates a problem with the indoor unit's evaporator temperature sensor. This sensor measures the temperature of the evaporator and sends a signal to the air conditioner's control board. If the sensor is not working properly, it can cause the air conditioner to shut down and display the E6 error code.
To fix this issue, you may want to try the following:
- Check the sensor wiring and connections to ensure they are secure and not damaged.
- Test the sensor with a multimeter to check for continuity. If the sensor is not reading correctly, it may need to be replaced.
- Check the air filter and clean or replace it if it is dirty.
- Check the evaporator coil and clean it if it is dirty.
- If the problem persists, it is recommended to consult a professional technician to check the air conditioner, or contact the Hyundai customer service for assistance.
It is important to note that these instructions may vary depending on the air conditioner model, so it is best to consult the user manual for specific instructions.
I have a hyundai curved electric wall hung heater, the living flame stopped working how can i fix please
You will need to assess the problem to determine if it is loss of power (circuit breaker or GFCI or overload tripped on the unit), failure of controls (thermostat or switch), or if the heating element(s) or burned out (open circuit or very high resistance on Ohm meter). Once you have that information you can proceed to purchase the necessary part(s) or reset the tripped power safety -- but if it trips again you need to diagnose why that happened.
Not finding what you are looking for?