Hoshizaki Freezers - Page 3 - Recent Questions, Troubleshooting & Support
Why does my KML-600MAH only make water not ice?
Check to see how long it stays in the freeze cycle. normally it takes a least 20 minutes to make a batch. If less than that, you are probably loosing water causing an early harvest and almost no ice.
6/17/2017 11:08:35 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
Ice machine keeps freezing on the ice trays
If you are referring to the ice not clearing the evaporator plates, usually the defrost cycle is too short. Check that by watching the machine and when it goes into the harvest mode, see if all the ice comes off. If not, lengthen the cycle.
6/17/2017 10:59:12 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
Hoshizaki km-1900 ice sitll up no going down
if your are referring to a harvest cycle not clearing the plates, there may not be enough heat to clear the plates or the defrost cycle is too short. Usually the first thing to check. start there my friend.
6/17/2017 10:56:10 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
HOW DO YOU CHARGE R404 A SYSTEMS REFRIGERATION
First question, why do you need to charge the system? Second is it a remote unit or self contained. Third do you have a set of refrigeration gauges? The best wau is to weigh the proper charge into the machine through the gauges. That varies depending if you are air cooled, water cooled or remote.
4/6/2017 1:21:25 PM •
Hoshizaki...
•
Answered
on Apr 06, 2017
Hoshizaki ice machine will not power up
with not model or serial numbers, I can only suggest that it may very well be the "bin stat". This is a thermostat that has a sensing bulb that is in the bin and senses the ice when it touches it to shut down the machine. If this is bad, no power goes to the control board. Try jumping this out with a jumper wire and see if the machine comes on.
2/11/2017 10:17:54 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
2 problems one water escaping
first, freeze cycle too short because you are loosing water. Water may be leaking thru the dump valve. Look at drain while machine is running and see of alot of water is draining. The dump valve spring may be week or there is trash in the dump valve preventing it from seating properly. drain water first before pulling dump valve apart.
2/11/2017 10:16:01 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
Not finding what you are looking for?