Haier Freezers - Popular Questions, Answers, Tips & Manuals

You can try resetting it by unplugging it for 10 minutes.

The Ed error code is referring to the defrost heating system.

5 Most Common Freezer Problems and Solutions

https://www.searshomeservices.com > blog > 5-most-common-freezer-prob...

#1 PROBLEM: My freezer is making strange noises. ... Keep in mind, though, that not all freezers will make exactly the same sound when this ... If everything is working, then the noise is probably just the appliance going ... Frost forming around the freezer door's gaskets indicates the door was not fully closed. .... Sign me up ... Missing: 5.3 ‎cu ‎ft ‎HNCM053E

probably a fault in that switch

If compressor isn’t running, it’s either a thermostat / control board problem, or a power supply problem.

If compressor isn’t running, it’s probably a thermostat problem

https://www.haierappliances.com/support/freezers/troubleshooting try this web site for direct answers from the manufacturer.

https://www.haierappliances.com/support try this site to ask you question directly to the manufacturer.

https://www.manualslib.com/brand/haier/freezer.html Identify the model and free manuals online at the link shown. Haier Freezer manuals

https://www.haierappliances.com/support/freezers try this web site and contact the manufacturer directly. They also have manuals. just surf their site.

http://www.manualsonline.com/ I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

You may have a refrigerant leak. First make sure the lid has not warped and leaving an air gap for heat to enter. That's really about all you can do without getting a tech. involved. I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

On some small units such as this, the condenser coil is actually in the walls of the cooler. It is not that unusual for this type of construction. I have seen this in chest freezers and other such units. If the unit makes the desired temperature, I would watch it for a day or 2 before putting any product into it to ensure it is okay and so you don't loose any product.

see if this link helps you out. how to get wedge drawer open Google Search

I use this on a regular basis and have had no issues. I believe it will work. If I had some numbers from the compressor plus a brand name such as Copeland, Tecumsah, embraco, etc., I may be able to tell you more about the compressor HP.

Looks like an 18cuft

I would check the power relay.

A&E got ya they got there pay twice if warranty CO. sent them out they were paid by them and by you something sound wrong there call A& E demand explanation

Either way if you had the doors opened a lot, it should like you probably have frost build up preventing proper air flow. You'd need to pull everything out of the freezer and remove the lower back panel inside the freezer. If there is frost build up, you'll need to use a hair dryer to thaw all the frost out. The unit will continue to beep until the set temperature (0 and 38) are reached so that could take a while even after thawing out all the frost build up. If removing panels sounds like more than you can handle, you can always unplug the unit for 24 hours and leave the doors open to allow the unit to defrost on it's own.

check thermostat, or relay on one side or back cclose to the compressor area there is a removable lid. removed and look for a thermostat disconect the 2 wires and bridge them then plug the the freezer on if runs replace the temp thermostat for a new one should be freezer thermostat