GE Ovens - Page 8 - Recent Questions, Troubleshooting & Support

actually it takes less time to heat up and cook with the fan running That is why it is called a fan forced oven as the fan forces the hot air all around the oven , heating it quicker and giving a better cooking result by moving hot air all around what is being cooked

Try unpluging the oven for about 5 minutes and then plug it back in. It should reset itself.

F2 means it thinks the oven temperature is over 900 degrees with the door locked. You can try to cycle the power to the oven to clear the code. If that doesn't work then it could be the temperate sensor, or the relays bad or shorted out. Here is a amazon link for a relay that should look similar to what you have depending on your model #. Amazon com GE WB18T10352 Relay Home Improvement

Hello, You should replace the door lock mechanism and the door switch. Global Solutions Appliance Repair https://gsappliancerepairnyc.com/

f7 err code means problem with the control panel.control panel needs to be replaced.if u like u can try for a temporary fix.open up the control panel by removing screws at the bottom of the conrol panel.disconnect the ribbon connector which comes from the control panel and connects to the control board.take a piece of paper towel and clean its end and put it back.some times this works.do not forget to turn of the power b4 doing this.

F1 error and beeping. Don't bother getting GE out there. Cost me $90 to learn they don't make the clock. WOuld have been $500+ for the control panel anyway. Better off just buying a new one. Planned obsolescence I guess. I won't buy GE again.

Hi

F1 Error indicates a bad control board and the control board (electronic control) should be replaced to solve this issue. Hope this helps...please post back for further assistance.

Daniel

If possible i will need the letter that come next after the JKP15.

First, I'm not a GE tech. * Check your warranty. Call for service. *** The following is for information only *** * GE Self Cleaning Oven instructions (a bit fuzzy); https://www.youtube.com/watch?v=2_hO7R29E9Y * Updated video (steam clean version); https://www.youtube.com/watch?v=yg3EBU99PSE * Older models (my mom's stove 1970's); https://www.youtube.com/watch?v=uBQa_yIyfgI * Be safe contact GE for specific questions.; http://www.geappliances.com/ Aloha, ukeboy57

Unfortunately, the F91 error indicates that the door lock is not functioning or the signal that the door is locked didn't get to the control unit. The range will not begin the self-clean cycle if there is a chance that you could open the oven door when the oven is dangerously hot. First try cycling the power by unplugging the range (or turning off the circuit breaker). Next check if the lock has engaged. If the lock doesn't engage, check if the mechanism is bent or binding. Next check the wiring to see there is damage that will prevent the communication between the control board or the door lock. Check for corrosion at the wiring harness connections. If the error happened after doing a self-clean, I'd suspect the door lock hadn't released. That can be related to a damaged over-temperature sensor or the lock itself. If the range has been self-cleaned before, it's possible that the lock was broken after forcing the door to open after that self-clean cycle. You may need to replace the lock, the wiring or the control board. Please add a comment with the model of your range for a parts diagram. If your range is under warranty, contact GE. I hope this helps. Cindy Wells

Yes the lock must be disengaged. If you cleaned it the lock will stay locked until the oven cools down to a safe temperature.

The main control board for the oven is fried.

sounds like a faulty thermostat