GE Dishwashers - Page 3 - Recent Questions, Troubleshooting & Support
Ge dishwasher fault code 3h
Sooo with my model just for anyone looking this up. My son loves pushing buttons and one of his favorite is the “delayed start” button. After researching, cleaning out the filter, unplugging the dishwasher and most everything short of pulling my hair out, I found out that the little nugget had pressed the delayed wash button. Which, you would think would reset when you reset the machine but evidently not. Pushed the delayed start button and cycled through 12 hrs and bingo, it ran....
Not a fun way to spend the night but at least I saved money by not having to call out a repair man. ??
Uninstalling a ge potscrubber 900
Shut off power to dishwasher at electric panel,shut off water supply,open door of dishwasher,remove screws on top side of dishwasher that are screwed into the underside of the countertop,,remove the front service panel on the bottom front face of the appliance by removing two or more screws on the right and left,locate and disconnect the water supply feed,locate and disconnect the electricity supply cable,locate and disconnect the drain hose usually connected to the drain of a nearby sink,pull dishwasher out of cavity in cabinet by grasping both sides of dishwasher with door slightly open,adjustment of front legs of appliance may be necessary.
Hi
I'm getting an E4 code on my GE dishwasher, tried turning power of for 24 hours it fixes it for 1 wash and then code returns.
E4 means dishwasher sensor is detecting the dishwasher is over filling. First thing I would check is the float. You will want to make sure it travels up and down freely. Open your dishwasher door all the way. Look on the right hand side (could be in a different location on your model) you will see a round thing. Kind of looks like a air hockey pusher. Try moving it slowly up and down making sure it’s not stuck open.
If this didn’t work then I would lean towards a faulty sensor.
It’s possible you could have a faulty board as well.
It is my opinion unplugging it will have no effect on this particular issue.
I hope this information has helped. God bless and have a great day.
Ge quiet power 3 dishwasher
According to the GE repairman who visited, the solution is to close the machine (with the lights flashing). The machine starts and goes through the cycles, which it does rapidly and then all the lights turn off and the machine becomes silent after 1-1/2 to 2 minutes. Then the machine has been reset to normal. During this reseting period nothing happens inside the machine, although you may hear a running sound.
Thus, the solution is to run the machine in this flashing light state for the 1-2 minutes it takes to go raipdly through each cycle and then reset.
I hope this helps.
Not finding what you are looking for?