GE Dishwashers - Page 2 - Recent Questions, Troubleshooting & Support
Our PDW8280J03SS caught fire and brunt out at the
You should tell the manufacturer as it is obviously a generic problem if there have been recalls. Ask them what they are prepared to do for you. You must put it in writing, no use using the phone.
I hope I have been of help but please do not hesitate to ask if you have any further questions.
I appreciate your vote if you appreciate my reply.
Need a diagram for the
I have GE Dishwasher (model no:GSD1100G02),and for the last few month I was not able close the main detergent cup cap(it is coming back to full open position,even after keeping the CAP turned all the way to a closing postion)
I have called the GE spare parts division,and obtained the New detergent cup cap,and when I tried to remove the old one,inorder to replace with the new one,I was not able remove old one.
Please help me how to remove the old main detergent cup cap,and replace with a new one.
Hope I will hear from you soon in this regard.
Murthy Pillutla
Home Ph:630-428-3277
Cell:484-919-3653
12/28/2021 3:36:34 PM •
GE 24 in....
•
Answered
on Dec 28, 2021
Makes a funny noise
I had the same problem with my Triton XL Model # - GSD6660G02SS Dishwasher. I tried adding water, zip tied each wash arm (one at a time) and had no positive result. Then I noticed a notch on what is called the docking cone. It supplies water to the middle wash arm. When the upper rack is pulled out you can see the cone at the back of the washer. Anyway I put a rubber O ring on this notch and the noise stopped. I can't tell from the parts list if the O ring is supposed to be there or not. Maybe a GE repair tech can confirm this. Hope it works for you as it did for me.
-Mark
How do i remove the kickplate on a portable GE dishwasher
how to Remove the Toe Plate on a Dishwasher
- Inspect the toe kick plate on the bottom of the dishwasher for screws. ...
- Remove the toe kick plate screws with a Phillips-head screwdriver or Torx #20 screwdriver.
- Slide the toe kick plate away from the dishwasher. ...
- Locate the access panel just above the toe plate. ...
- Lift off the access panel.
GE dishwasher started but didn't run. Now does nothing.
You did not post the model number but to reset a dishwasher, you unplug it or if it is wired directly, Locate the breaker that it is on and switch the breaker off for a couple of minutes. There should be a service guide attached to the unit in a folder or bag
Not finding what you are looking for?