Did you clean the surfaces thoroughly and glue it down with white or clear silicone, then leave it to cure? also was it an OEM replacement or an Amazon special as the quality is different.
It is called short cycling. Help below
If your refrigerator is short cycling, it can be caused by a number of issues including: An incorrectly set thermostat inside your refrigerator. Dirt and dust on the coils that prevents efficient operation. Faulty capacitors or relays that prevent the compressor from staying on.
Apr 14, 2019
JustAnswerhttps://www.justanswer.com > Appliance Repair
Sep 30, 2014 - i have a frigidaire freezer and its short cycling, it runs about 6 to 10 minutes and then cuts off. what can be the problem and how can we fix ...
1 answer · Top answer: OK so there are only 2 things that can cause this issue---either the defrost timer or the thermostat ...
The E6 error code on a Frigidaire wine fridge, specifically the model FGWC5233TS, indicates a fault with the upper temperature sensor. When this error code is displayed, it means that the temperature sensor located in the upper portion of the wine fridge is not functioning properly or is experiencing a malfunction.
To troubleshoot and resolve the E6 error code, you can try the following steps:
Unplug the wine fridge from the power source for a few minutes and then plug it back in. This may reset the error code and resolve any temporary issues.
Ensure that the wine fridge is properly leveled. Uneven positioning can affect the performance of the temperature sensor. Adjust the feet or placement of the unit to ensure it is level.
Check for any obstructions or blockages around the upper temperature sensor. Make sure there are no items blocking the sensor or disrupting its operation.
If the error persists, it is recommended to contact Frigidaire customer support or a qualified appliance technician for further assistance. They can provide specific guidance based on the model and help diagnose and repair the issue with the upper temperature sensor.
Depends on model. Generic advice in the link and videos. You can effect a power reset by pulling that wall plug for 30 minutes.
Sabbath Mode is turned ON and OFF by pressing
and holding both the freezer "? Down" and refrigerator "? Up"
indicators for five (5) seconds. The display shows "Sb"
while in Sabbath mode
https://www.google.com/search?q=how+to+turn+off+sabbath+mode+on+frigidaire+refrigerator
..
Question edited for clarity.
It sounds like the compressor is struggling / overheating / failing. When was the last time your stripped the back out and removed all the fluff and debris? It overworks the compressor and gets red hot when the condenser coils get blocked. The struggling compressor causes the humming. Turn it off, keep the doors closed and vacuum it all out. Clean underneath and you might as well clean the floor and walls around it as the plan is to leave it disconnected for 1 to 2 hours to cool down and settle the refrigerant gas/liquid. Some other ideas below.
The evaporator fan motor circulates air over the coils to help keep things cool inside your fridge. If this motor starts to go bad, it will make a buzzing sound as it struggles to circulate air. You'll need to replace the evaporator fan motor to fix this problem.
Aug 22, 2022
JustAnswerhttps://www.justanswer.com > Appliance Repair
Apr 24, 2022 - To put a Frigidaire refrigerator in demo mode, hold the Energy Saver and Adjust Freezer buttons at the same time. Press them for three seconds ...
1 answer · Top answer: great !, Happy to help !
limited information ---unable to give an answer --since you need to test the unit most likely problems overheated/failing compressor [dirty/restricted air flow condenser area --condenser-evap fan fail /short--circuit short ---------breaker failing [but if tripping and resets normal usually not the case ]
Does ir look the same as this FRT18?
https://www.ajmadison.com/cgi-bin/ajmadison/FRT18G6JW.html
Refrigerator Capacity: 14.13 Cu. Ft.
Freezer Capacity: 4.07 Cu. Ft.
Total Capacity: 18.2 Cu. Ft.
Width: 29 5/8 Inch
Depth: 33 5/8 Inch
Depth with Door at 90°: 59 7/8 Inch
Height: 66 1/8 Inch
No. of Shelves: 2
Gallon Door Storage: Yes
Water Dispenser: No
Yes, very often they make one wiring harness to cover a number of models in the series, which means you have redundant wires. If everything works, don't worry.
One trick is that permanently connected wires sort of set in place and naturally reach out towards where they were connected. also, a wire will only fit things within reach within an arc.
Broken wire? Faulty mainboard?
You can test for power with your digital multimeter or with an electrical proximity tester. Also check the wall socket with something known to work, like a table lamp, phone charger or a vacuum cleaner.
Call for service. If it is the mainboard, you need the correct diagnosis and warranty on the part and the labour.
..
The steps to change the temperature display from Celsius to Fahrenheit on a Frigidaire PHSC239DSB5 refrigerator may vary depending on the specific model, but generally, it can be done through the control panel. Here are some steps you can follow:
Locate the temperature display on the control panel of the refrigerator.
Press and hold the "Option" button until the display starts flashing.
Use the "Option" button to toggle through the display options until you reach the temperature display setting.
Use the "+" or "-" button to switch from Celsius to Fahrenheit.
Once you've made the desired change, press the "Option" button again to save and exit.
Note: The specific instructions may vary depending on the model, so you may want to consult the user manual or the manufacturer's website for more detailed instructions.
If your Frigidaire Gallery side-by-side French door refrigerator model FGHF2366PFBA is not making ice after you switched the water filter, there are a few things you can check to troubleshoot the issue:
Check the water pressure: Make sure that the water supply to the refrigerator is turned on and that the water pressure is adequate.
Check the water filter: Make sure that the new water filter is installed correctly and that it is not clogged.
Check the water inlet valve: Make sure that the water inlet valve is not clogged or malfunctioning. It is located behind the refrigerator and controls the flow of water into the ice maker.
Check the ice maker arm: Make sure that the ice maker arm is not stuck in the off position.
Check the thermostat: Make sure that the thermostat is set to the correct temperature.
Check the control board: Make sure that the control board is not malfunctioning.
If the problem persists after checking these things, it may be best to contact a professional technician to diagnose and fix the issue.
