Flowtron Garden - Recent Questions, Troubleshooting & Support

Question edited for clarity. Try the maker, but I doubt they sell spares.

Flowtron Outdoor Products

https://www.flowtron.com Mosquito Control · Power Trap · Power Trap · Power Trap Plus · Power Vac · Insect Killers · Fly Control · Electronic Fly Control · Adhesive Board FlyControl ‎Parts and Accessories · ‎Insect Killers · ‎About Flowtron · ‎Mosquito Control

how would we know we are not the selling agency

Simple Google search for Flowtron LE-900 manual, right on Flowtron.com site. For more help, just contact Flotron: http://www.flowtron.com/mm5/merchant.mvc?Screen=CU&Store_Code=F I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

Manual is here: https://www.flowtron.com/manuals/357%203151%20REV%2011%20LE-900%208pg%20OM.pdf Says on Page 9 to "Remove screw and "O" ring, lift spinner off shaft." I would assume you need to hold the spinner from moving when removing the screw. If the screw threads are stripped and it turns but won't back out see if you can grab the screw head with pliers or vise-grips. I’m happy to help further over the phone at https://www.6ya.com/expert/donald_f2ed37026a3ac881

I would recommend contacting the manufacturer. The warranty was 1 year. If you are at 13 -14 months, I would ask Flowtron for some help in getting it replaced. Sometimes manufacturers are willing to split the cost of a repair that is near the warrany end to help keep a customer satisfied. It is worth trying.
Good luck.

FLOWTRON OUTDOOR PRODUCTS
15 Highland Avenue
Malden, MA 02148
Telephone (781) 321-2300
Fax (781) 324-8403
Parts & Service: [email protected]
Sales: [email protected]

You can't chop wet leaves, and is it plugged in?????

sounds like you have an arc occuring. arcs occur for one reason only, somewhere, there is a current being transfered back to its source. check your power outlet for proper wire configuration and voltage. should be anywhere between 108-122V (or very close to that) if doubled then you have to reconfigure the breaker panel to cut the voltage in half. If all looks good, then you have a defective piece and they owe you your money back. somewhere in the internal workings there was either a wire or component that wasn't properly insulated or a regulator that isn't configured properly. DO NOT USE THIS MACHINE!!. turning in on briefly for testing is one this, but running it for work can be very dangerous.
I recommend getting your receipt and calling them for a replacement. If you purchased it within the last 30 days you can bring it back to the place of purchase.
FLOWTRON OUTDOOR PRODUCTS
15 Highland Avenue
Malden, MA 02148
Telephone (781) 321-2300

GOOD LUCK AND PLS RATE THIS POST!!!