Fantom Vacums Vacuums - Recent Questions, Troubleshooting & Support

Fantom Vacuum Cleaners - Parts - Hepa Filters

Go to www.fantom.com. In Support Wizard, type in your model number. You'll see a file called Product Manual. click it to open and print.

Carol, Have you checked to make sure that all of the filters have been cleaned so that you have good air flow? The HEPA filter is your final exhaust filter and if your motor is getting hot because of poor air flow, it will cause the HEPA filter to get hot as well. Hope this helps!

I can locate one for you, if you can supply me with the model number of your vacuum.

I have one for sale if you are still interested, and other parts for this vacuum. :)

I have two for sale if you are still interested, and other parts for this vacuum. :)

your best bet would be to try Ebay or something like that. These units were discontinued late 1999/early 2000 and no parts are available for it.

my best suggestion in this case is to invest what you would spend on the powerhead into a newer cannister. Some of the newer units have better filtration and suction than the lightning cannister does.

on all vacuum cleaners the air flow cools the motor. If the filter is sufficiently clogged there would not have enough air flow to cool the motor and trips out from over heat. Clean out the filter thoroughly and try again.

Hi I have a lightweight phantom bagless vacuum. Wondering if I can rinse the filter with water?

May have a faulty wire or there could be something rapped around the spook at the end jamming it enough to strain the motor and slow the spinning

Check the fuse, replace if blown WITH SAME RATING FUSE. If there has been any damage caused to the cable, have this replaced by A QUALIFIED ELECTRICIAN.

Have you tried down loading off internet?