Evenflo 1556C Home Decor Swing Gate... • Uploaded on Mar 24, 2014
Evenflo 1556C Home Decor Swing Gate... • Uploaded on Mar 24, 2014
1. Remove the truck from the Exersaucer. The base has four tabs that need to be slightly deflected to remove the base.
2. Turn the base over and remove the four screws holding the truck to the base. Remove the truck from the base.
3. Using a utility knife and following the seam in the plastic, make a slice down the center of the windshield decal and the back window decal.
4. Using a #1 Phillips head screwdriver, poke a hole in the decals of the front and rear driver's side windows. The hole is to be located halfway down the window, and an 1/8" (3mm) from the back or rear of the window respectively. In each hole, there is a Phillips head screw to be removed.
5. Remove the screw in each wheel on the driver's side.
6. Separate the two halves of the truck body, remove the center assembly. It may be stuck due to the glue on the side window decals. The yellow and red lights can be pushed out from the outside of the truck.
7. Locating the circuit board you can see the three batteries under retainers.
8. Remove the four screws holding the circuit board to the center assembly.
9. Bend up two tabs on the battery retainers and push the batteries out of the retainers.
10. Replace the batteries.
11. Reassemble in reverse order.
Evenflo Titan Sport Convertible Car... • Uploaded on Mar 09, 2014
Evenflo Jenny Lind Crib • Uploaded on Oct 28, 2013
Evenflo Snugli Front & Back Baby... • Uploaded on Oct 28, 2013
Evenflo Jenny Lind Crib • Uploaded on Oct 08, 2013
585 questions posted
Usually answered in minutes!
202 Questions
28 Questions
23 Questions
19 Questions
17 Questions