Ertl Toys - Page 6 - Recent Questions, Troubleshooting & Support

Disconnect linkage. Remove differiental lock housing located on right side of transaxle. Ck for repair issuses. Ck sliding gear, spring engagement, etc

my 580b case didnt have a block heater. i purchase a new one from my local dealer and the instruction tell me to mount it in the block on the drivers side. in behind the fuel filters are 2 plugs...or in my case 2 nipples because mine had a cab heater hooked up..it says to use the rear most port

sorry no idea here wouldnt even know one if it jumped up and bit me

Pregunta , tienes, el manual de la case 580 ck, donde se muestra el circuito hidrailico de la transmision, si es asi, embiame una foto del circuito o el manual y te puedo apoyar.

Hi,
I have been on so many tractors and not on one of these in many years... but doesn't this one shut off by pulling a knob out to shut the fuel off at the injector pump??

It seems to me that the fuel shut off cable can get corroded from rain and moisture and become hard to pull so the engine is hard to shut down. You can take the cable loose and get WD-40 worked into it by holding one end high and running it down the wire into the cable.. then when you get it working, run a light oil into the cable to keep it lubed up...

I don't think this tractor has an electric solenoid valve... but if it does then that valve is going bad and not shutting the fuel off...they also can stick. They can be taken apart and cleaned also...

heatman101

You are having the typical shuttle failure. There is a bellville type spring that returns the clutches when pressure is taken from the clutch pack. That spring will fail with time, it is nothing you did.