Cuisinart Microwave Ovens - Popular Questions, Answers, Tips & Manuals

Try looking here......you'll need to find the model# sticker probably on the back?. https://www.ereplacementparts.com/cuisinart-parts-c-147322.html?source=gaws Best to you.

Only one video on that model. They are normally Torx security screws and hidden under rubber feet. https://www.google.com/search?q=cuisinart+afp-7+disassembly Parts. Terrible site, no parts diagrams! https://www.cuisinart.ca/parts-food-processor-choppers?lang=en ..

There is no filter to clean according to the manual. They suck clean air into the keep the electronics cool, channel it into the cooking cavity, pick up steam and smells and vent it out untreated. Manual https://files.bbystatic.com/V6Uf8L3YK6TGThXmKv0djg%3D%3D/820227A4-9805-4BE9-BCE0-19F2A2B56A42.pdf ..

https://www.cuisinart.com/share/pdf/manuals/cso-300.pdf

The outer cabinet has to be removed to gain access.

No there is no fuse, have you checked to power to unit.

try replacing or changing the fuse with a new one

with a special / security screwdriver

do online search using make and model their are multi parts sites

It will be a broken plastic on the latch. U must however get the door open to examine it. That is the problem. Sorry and good luck If you need further help, reach me via phone at https://www.6ya.com/expert/gary_9c859f4aa7e5ab10

Could be the magnetron, I suppose.. Why is my microwave not heating up? This high voltage powers the magnetron to heat the food. If the diode burns out, the magnetron won't receive enough voltage to operate, preventing the microwave from heating. When the diode fails, it is often visibly burned out. Inspect the diode and if the diode is burned out, replace it. Test the Magnetron: http://www.microtechfactoryservice.com/mag_test.html

Faulty control panel switch or control board. Click on link: https://www.cuisinart.com/share/pdf/manuals/cmw-100.pdf

Sometimes mating the bowl to the base does not depress the indented safety start button at the front of the base. This can happen more often if you pre-assemble the bowl and lid before mating to the base. Sometimes also the plunger rod in the bowl (that pushes the indented safety button) gets fouled with debris and does not slide nicely up and down. You may have to clean that area. Test the safety button .... take the bowl off and take a small screwdriver to depress the button while activating the start lever. BE CAREFUL ... since the center drive cylinder will spin. If the motor turns on and drive cylinder rotates then the problem is how the bowl was mated to the base. If the motor does not turn on ... then it could be the motor/wiring/switch. Helpful? Good luck with your troubleshooting

The circuit board must be replaced.

Try adding extra yeast.

Order a new turntable motor. Turn the microwave upside down and you can see the little door in the center where you can install it. Pretty easy, really.

have you tried ebay?

they all do as it is a safety requirement to control the microwaves from cooking anything outside the enclosure

If you wish to get some details about microwave oven repair then check the following link. http://electro-medical.blogspot.com/

call cuisinart - their CS was pretty accommodating for me on another product.