Canon FAX - Recent Questions, Troubleshooting & Support

That is Fixing unit error . Maybe is defective

Check the user manual

Code

E225-0001

Description

Light intensity of a lamp is less or equal to the criteria

Remedy

When the same error repeatedly occurs after several times of turning the power OFF/ON, execute the following remedies. (1) Check the connection of Flat Cable between Main Controller Board (J5) and Contact Sensor. (2) Replace the Flat Cable between Main Controller Board (J5) and Contact Sensor. (3) Replace the Contact Sensor. (4) Replace the Main Controller Board.

A factory reset to the original settings may fix the problem. Make certain your software is up-to-date and any changes to the canon firmware are current for your operating system.

Try unplugging it for a few moments they plugging it back in.

hi I need to CODE reset factory default printer model : CANON L150

How to resolve the code 225 in Canon Fax 150?

First things first. Try and print report from the fax. Any kind of report. If it is printing OK, then the next step is to check if: Your clients receive your faxes OK? If they are dark as well, then your scanner head is at fault. When you make Copy on your fax and it prints dark it could be simply set with dark settings _or_because of the white calibration strip or roller being soiled or dirty, which acts as the ultimate white reference point for scanner _or_ the Scanner CCD sensor is in paper jam release position (too far away from reading the originals) just pull it back to normal feed position. Or simply faulty scanner.

Canon SENSYS FAX L150

You need to check the settings for scanning. The machine wants to use the platen because that is what it has been set up to do, or you are using a sheet size the machine doesn't know about. Again go through the scanner settings both on the machine and any attached computers.

Here is a link to the Canon download page. Here you can download all the software and information that would have been on the disc so you can set up your printer wireless. Canon SENSYS MF4780w

Following Occam's Razor, the first thing to do would be to replace the black ink cartridge.

Try unplugging other phones (from the phone jacks) that are on the same line. Also, remove any phone that is plugged in to the fax machine, if there is one attached. If that doesn't work, swap the phone cable on your all-in-one printer/fax with a different one. Lastly, try a different phone jack all together. I can tell you I had the same problem with my fax/printer, and it ended up being a bad phone cable. It, the cable, worked fine with a handset, but not with the fax. Good luck.

Tis not something that can be reset as far as I am aware. To do it.. It's a big job! Printer needs to be taken apart*, thick felt ink pads need to be washed in water and fully dried (or replaced if you can get any) and then rebuilt. *this is much harder than it should be!

Go into the menu. In the FAX Settings the RX Mode Settings section and turn on the FAX ONLY setting. If all is well then it will receive. If it does not then check that you are using the genuine Line lead that can with the machine.

Hello, my name is Steve. It sounds like your Fax machine has detected that the phone lie to your machine is still "opened". The Fax board that detects the signal for the incoming fax tone is either not connected or it has an open circuit. If you have another cable that goes to the Fax try this as a replacement. If this corrects the problem, then the fault is the cable from the connection of the wall to the fax machine. If this does not, then if you have another source, connect it...like a telephone. If you hear a dial-tone then it is not the line-in. The part that failed is the Fax-card or the Logic board... I hope this helps, best regards,steve