Canon PowerShot - Answered Questions & Fixed Issues - Page 6
A530 flash problem
in this model the flash IC becomes faulty if so u should consult an expert.
Operation panel buttons not responding
That control board is shot or perhaps the connection to the main board is at fault. Shame but repairing those cameras is very labor intensive and hard to work on. And the parts are not cheap either. I am crazy about my SX 50 but if anything like that happened to me I would just go to ebay and get another one inexpensively. Many repairs on cameras are simply not cost effective.
Camera does not recognize any sd card
See if camera electronics can be reset. Contact the manufacturer for this procedure. If nothing can be done to restore camera to factory defaults then the electronics are fubar. May not be cost effective to repair.
I think I need a
just down load it
and then you click on the downloaded file and it should install the software.
the link below will automatically detect the windows operating system you are using if you are using windows
https://www.usa.canon.com/internet/portal/us/home/support/details/cameras/support-point-and-shoot/powershot-sd-elph-series/powershot-sd850-is?tab=drivers_downloads
My Canon powershot A1100 IS is not focusing at
The focusing gear on that motor is stripped and the lens cannot focus. Not cost effective to repair. Canon will charge small fortune for the part and then the LABOR. Workiing on those small cameras is one royal PIA and labor intensive.
Horizontal lines
Try a hard reset of camera electronics. Canon may have a hidden code to do this with. Suspect your electronics are fubar and you may have to go shopping since repair is not cost effective. Shame - good camera.
Canon powershot 1200 stolen need serial number
Can't help you this time but when you purchase anything you should have a note book and write all the information in it then you would not have this problem. A lot of people do not think of these things.
When downloading photos, camera reads as "No Images"
I would look at the connection ports. Sometimes dust,dirt gets in there..Try blowing air into the connectors. You can use you mouth breath but a small air compressor works better..But I wouldn't over do it with to much air pressure... My iPhone mic was dirty...No one could hardly hear me...I done this and now they hear me good...Worth a try...It could bent prongs in the port or a bad cable. Good luck.
No Memory Card error
Check to see the largest capacity card that the camera will accept - if you are trying to use cards larger than this, I would expect this error.
Not finding what you are looking for?