Buck Plumbing - Page 9 - Recent Questions, Troubleshooting & Support
How to disable moine faucet
Can you tell us more about what you mean by Disable?
If you mean,how can you stop water from flowing, there are usually shutoff valves in the hot and cold water supply lines under your sink (nothing to do with the faucet itself).
11/18/2019 11:55:18 PM •
Plumbing
•
Answered
on Nov 18, 2019
I replaced my pressure switch with one that has a emergency low pressure off switch.
There are a lot of variables. Are you on a shallow well pump? It sounds like the well doesn't make much water. Check your well tank pressure. With 0 psi of water (drain the pressure) There should be 2 psi of air less than than the start up. If the pump is set to start at 30 psi, there should be 28 psi of air in the tank. It sounds to me like either the tank is shot, or the pump doesn't make much water. If you leave a faucet on while putting air in the tank and air comes out the faucet, then, the bladder is shot.
10/30/2019 9:01:33 PM •
Plumbing
•
Answered
on Oct 30, 2019
Mastercraft 62-3593-2 jet pump
That pump doesn't have a pressure switch! It has a digital flow sensor on discharge. It will keep running so long as there is a flow. Usually caused by dripping tap, or leak. Pressure doesn't stop the pump. By the way - Don't expect to get parts from Canadian Tire or Mastercraft - They told me that they carry NO parts for that pump. It is very similar to a Burcam pump and they may have parts or offer service.
10/17/2019 1:18:02 AM •
Plumbing
•
Answered
on Oct 17, 2019
How often should you replace a Watch Dog backup sump pump?
The most likely component failure is the battery. It should last several years when properly maintained and desulphated.
When properly installed the pump only runs when theres a failure with the primary pump. So it should last indefinitely.
10/8/2019 3:49:14 PM •
Plumbing
•
Answered
on Oct 08, 2019
Not finding what you are looking for?