Garden - Page 12 - Recent Questions, Troubleshooting & Support
Won't crank over, quit in middle of mowing
If your mower won't crank over and quit in the middle of mowing, there could be several possible reasons for this issue. Here are some common troubleshooting steps you can take:
- Check the Fuel Level: Ensure that there is enough fuel in the mower's tank. If the fuel level is low, it might not have enough fuel to run.
- Inspect the Spark Plug: A fouled or damaged spark plug can prevent the engine from starting. Remove the spark plug and inspect it for signs of fouling, such as deposits or a worn electrode. Replace the spark plug if necessary.
- Fuel Quality: Make sure you are using fresh, clean fuel. Old or contaminated fuel can cause starting problems. Drain the fuel tank and replace it with fresh fuel if needed.
- Air Filter: Check the air filter for dirt and debris. A clogged air filter can restrict airflow to the engine, affecting its performance. Clean or replace the air filter as needed.
- Check for Obstructions: Inspect the mower deck and the blades for any obstructions or debris that could be preventing the blades from turning freely.
- Safety Switches: Most mowers have safety switches that prevent the engine from starting if certain conditions are not met (e.g., the blade engagement lever is engaged, the seat is not occupied). Check these safety switches to ensure they are functioning correctly.
- Battery: If your mower has a battery, check its charge. If the battery is low or dead, it might not provide enough power to crank the engine. Charge or replace the battery as necessary.
- Ignition System: Inspect the ignition system, including the ignition coil, for any visible issues. If there are problems, such as damaged wires or connections, they may need to be repaired or replaced.
- Fuel System Issues: Problems with the carburetor or fuel lines can also cause starting issues. Inspect the fuel system for any clogs, leaks, or other issues.
- Examine the Oil Level: Ensure that the oil level is within the recommended range. Low oil levels can lead to engine damage and difficulty starting.
If you've gone through these steps and the problem persists, it may be best to consult the mower's manual or seek the assistance of a professional mechanic to diagnose and address the issue.
11/20/2023 12:21:08 AM •
Garden
•
Answered
on Nov 20, 2023
How do I remove the gas tank on a Poulan Pro PPBP30/30cc gas backpack blower?
To remove the gas tank on a Poulan Pro PPBP30/30cc gas backpack blower, follow these general steps:
1. Ensure the blower is turned off and cool before starting any maintenance.
2. Locate the gas tank on the blower. It is typically positioned near the engine.
3. Look for any screws or bolts securing the gas tank to the blower. Use the appropriate tools, such as a screwdriver or wrench, to remove them.
4. Once the screws or bolts are removed, gently lift the gas tank away from the blower. Be cautious not to spill any fuel.
5. If there are any fuel lines or connections attached to the tank, disconnect them carefully by loosening the clamps or fittings.
6. Once all connections are detached, the gas tank should be free to remove completely.
Please note that specific models may have slight variations in the removal process, so consulting the Poulan Pro PPBP30/30cc gas backpack blower's user manual for detailed instructions is recommended.
11/19/2023 12:08:03 PM •
Poulan Garden
•
Answered
on Nov 19, 2023
Karcher K2 Compact - Motor permanently running/no pressure
It sounds like there may be a potential issue with the pressure build-up mechanism in your Karcher K2 compact. The constant motor running without water pressure could indicate a problem with the pump or the pressure switch. I would recommend checking the following:
1. Check the inlet filter: Ensure that the inlet filter is clean and free from any debris or blockages. A clogged filter can restrict water flow and affect pressure.
2. Inspect the nozzle: Make sure the nozzle is not obstructed or damaged. A blocked or damaged nozzle can restrict water flow and affect pressure as well.
3. Check the pressure switch: The pressure switch is responsible for regulating the motor and water flow. It's possible that the switch is faulty or not functioning correctly. Consider contacting Karcher customer support or a professional technician for assistance with checking and possibly replacing the pressure switch.
4. Examine the pump: There might be an issue with the pump itself. It could be worn out, clogged, or experiencing other internal problems. In such cases, it's best to reach out to Karcher customer support or a professional technician for further diagnosis and repair.
Remember to always follow safety precautions and consult the user manual provided by Karcher for specific troubleshooting steps and guidelines.
How much a person should get paid and hours for raking leaves?
Hi Joe
It depends who is doing it. Minimum wage for a kid or a little bit above for an adult cash job. Landscapers will want about $35 - $60 per hour per operative.
In my townhouse complex of 35 homes, the landscapers are charging $1,800 a week, usually a team of 4 and it takes an hour and a half. Prices in Canadian dollars.
..
11/17/2023 6:36:29 AM •
Garden
•
Answered
on Nov 17, 2023
Cub cadet lxt 1046 throttle cable how to change
For the most accurate and up-to-date information, I recommend consulting the official Cub Cadet LXT 1046 operator's manual. The manual typically includes detailed instructions on maintenance procedures, including how to replace components like the throttle cable.
Chainsaw chain rotates when starter pulley is pulled, why?
20" is long for a saw that size but that in itself didn't cause the issue. What matters is proper chain pitch/gauge and length (link count). According to the manual it's 3/8 pitch .050 gauge chain and by extrapolating link count, it should be 68. But that's assuming original drive sprocket pitch/gauge.
Remove the bar and chain. The clutch/sprocket should spin freely. Check the bar didn't make contact with the sprocket which would imply the chain tension wasn't maintained.
11/14/2023 10:49:43 AM •
Garden
•
Answered
on Nov 14, 2023
Bt 360 stihl
possibly a fueling issue, check fuel filter, tank vent and possibly replace carb diaphrams.
Countax c550 loss of transmission and cutting deck.
The owners manual shows 5 fuses. Remove and check each fuse for continuity.
Is the CHARGE indicator lit while engine is running?... regardless check battery voltage with a DMM. With engine running at medium throttle battery voltage should be >13.0VDC. Less than 12.6VDC implies charging system and/or battery failure. Less than 12.0VDC and electronics may not work properly.
The wiring diagram is included in the owners manual available no fee at the following URL.
https://www.manualslib.com/manual/32031/Countax-Garden-Tractor.html
11/11/2023 7:16:00 PM •
Garden
•
Answered
on Nov 11, 2023
Not finding what you are looking for?