Hello,
Just replace toner cartridge or refill the toner container with refillable sharp ar202 refill bottle or sachet. Remember to remove waste toner if you are refilling, right.
Question edited for clarity.
985 or 895?
Usually because the jam hasn't been cleared or the machine hasn't been reset.
Remove the paper tray an open the cartridge bay. Open the rear paper door, check underneath.
This machine has a lot of paper scraps in it. :>D
I've included a video tutorial at the end of these instructions. To change the bulb on your ELMO Omnigraphic 252 slide projector, follow these steps:
Safety First: Unplug the projector from the power source and allow it to cool down for at least an hour. This ensures your safety and prevents accidental burns.
Locate the Lamp Access Panel: Look for the lamp access panel on your projector. It's usually located near the lens or on the side of the projector body.
Remove the Screws and Access Panel: Use a screwdriver to remove any screws securing the access panel. Once removed, you'll have access to the lamp housing.
Remove the Lamp Housing: Reach inside the projector and firmly pull out the lamp housing. It might be held in place by additional screws; remove those as well.
Replace the Bulb: Take out the old bulb (lamp module) from the housing. Make sure you have a compatible replacement bulb. Handle the new bulb carefully to avoid touching the glass surface.
Insert the New Bulb: Slide the new bulb into the housing, aligning it properly. Secure it in place with any screws that were removed earlier.
Reset the Lamp Hours: If your projector has a lamp hour counter, reset it to zero. Refer to your projector's manual for instructions on how to do this.
Close Up: Put the lamp housing back into the projector, replace the access panel, and tighten the screws.
Remember to consult your ELMO Omnigraphic 252 user manual for specific details related to your projector model.
How to Change a Projector Lamp (youtube.com)
The E732-001 error on a Canon iR 3225 indicates an issue with the fixing assembly temperature. Here are some steps to troubleshoot and resolve this error:
Reset the Condition:
Enter service mode by pressing the following sequence on the control panel: COPIER > FUNCTION > CLEAR > ERR.
This will reset the error condition. If the message disappears, your printer is ready to use. If this doesn't work, there may be a hardware problem as addressed below.
Replace the Main Thermistor:
The main thermistor is responsible for temperature sensing. If it's faulty, it can trigger the E732-001 error.
Consider replacing the main thermistor to resolve the issue.
Check the DC Controller PCB:
If the problem persists, inspect the DC controller PCB for any defects or malfunctions.
Replacing the DC controller PCB may be necessary.
Remember to turn off the printer before performing any maintenance tasks. If the error persists or if you need further assistance, I recommend contacting your local authorized Canon dealer or the Canon Customer Support Center for professional service
Run it in reverse and pull the jammed paper at the same time.
Some have an overheat sensor and won't work for about 20 minutes.
Full 'make model (what it is)' in all questions as first 3 words please.
What could be the problem with this display? Tell me quickly.
