Humidifiers - Page 9 - Recent Questions, Troubleshooting & Support

Is the little ultrasonic disk clean, or is there hard scale on it? If there are hardened deposits on the disk they will stop it from vibrating. Be careful not to damage it by scraping or digging with a tool. I have found that the best way to clean it is with a Waterpik, turned all the way up. It often takes ten minutes of work to clear it off. This is MESSY, do it in the shower, or outside.

Is the little ultrasonic disk at the bottom of the mist tower clean, or is there hard scale on it? If there are hardened deposits on the disk they will stop it from vibrating. Be careful not to damage it by scraping or digging with a tool. I have found that the best way to clean it is with a Waterpik, turned all the way up. It often takes ten minutes of work to clear it off. This is MESSY, do it in the shower, or outside.

Those are disposable filters. They are about $20 each. When they get blocked up, they have all sorts of dust and other pollutants, and sometimes mold in them.

Try adding a pinch of salt into the water. filtered water does not humidify as good.

Call a vendor to ask for assistance. https://www.carelparts.com/ 800-825-2148

Thank you for your question. I can understand your concern about this error code. This code indicates the sensor has failed. However, if the touch pad is not responding it can also be causing this code to appear. If the touch pad does respond properly, the sensor # 610.14 will need to be replaced. The sensor is available at searspartsdirect.com/partsdirect/part-number/610.14/0046/461?pathTaken=directMatch&filterPart=&pop=flush&prst=0&shdPart=610.14&sid=MMLxexpertxmerch and sells for $2.16. You can call 1-800-469-4663 and someone there may be able to assist you with the cost of the service call and the technician will be able to give you an estimate for the repair. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further

After replacing the Water Panel, turn the control knob to the “Test/Reset” position until the “Change Water Panel” light blinks to reset the Water Panel change indicator timer.

English please.

You need to check to make sure the condenser fan is blowing and that the condenser coil is clean. You absorb heat inside the refrigerator, compress that heat with the compressor, then expel the heat at the condenser (the part of the system that blows hot air). If you can't expel that heat, the unit will lock itself out until you reset it

You may find your manual at one of these two sites. ManualsLib Makes it easy to find manuals online Free User Manuals and Owners Guides ManualsOnline com

https://www.youtube.com/watch?v=5UGxuBCxgT4

I DON;T KNOW. MOST WATER IS LET IN WHEN NEEDED BY FLOAT VALVE AT BOTTOM OF BOTTLE OR LOWER. PERHAPS IT NEEDS CLEANING. CONSIDER USING STRAIGHT VINEGAR IN LEAKING SIDE THEN GOOD SIDE. IF NOT OK, YOU MAY HAVE TO TAKE UNIT APART TO INSPECT FOR CAUSE.

https://tadanoamerica.com/dealers If anyone using Fixya is searching, this is a link to dealer phone numbers in the United States to request.

On the fan will be a model number. Ebay will be your best bet. Enter numbers into search bar.

https://www.manualslib.com/

If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ http://homenol.blogspot.com/

You have a short in there and that accounts for the tripping circuit breaker. If the insulation on the heating coil has gone that could be a good reason for the issue. Open it up and look for the short.

I don't know to start my humidifier, what do I need to do