Home - Page 6 - Recent Questions, Troubleshooting & Support
No water comes out of the wand
I had this problem and here is the solution. Remove the cover where the water supply hose goes into the diverter fitting. It is on the left side of the toilet and has a single screw. It is where the washlet shutoff valve is. On top of this valve (diverter) are two brass fittings. One is built into the diverter and the other is coming from the top. The top fitting should fit into the bottom fitting. If you look closely, the top brass fitting is connected to a gray hose. The two brass fittings need to be tightly coupled. If they come apart (by more than 1/8 inch) water will not enter the washlet. There is a check valve that will prevent water flow. Depending upon the manufacturing dates, there are units with and without fastener guides that hold these two brass parts together. Mine had a plastic piece which did a poor job of holding these pieces together. Customer support told me that I needed a metal fastener and instructed me to remove the plastic fastener. When I held the two brass parts together the washlet worked fine. So, when I get the metal fastener I expect the washlet to work again.
Need a manual for a Seiko melody in motion wall click. Model # QXM123BRH
Here is a manual for the Seiko Melody in Motion Wall Clock, Model # QXM123BRH:
Getting Started
- Insert one "AA" size alkaline battery into the clock's battery compartment.
- Set the clock to the correct time by pulling out the time-setting knob and turning it clockwise or counterclockwise to set the time.
- Push the knob back in to the "Lock" position to finish setting the time.
Melody Selection
- Press the "Demo" button on the clock's front panel to listen to all the available melodies.
- To select a specific melody, press the "Melody" button repeatedly until the desired melody plays.
Volume Control
- To adjust the volume of the melody, press the "Volume" button repeatedly until the desired volume level is reached.
Light Sensor
- The clock is equipped with a light sensor that will automatically turn off the sound and motion sensors when the room is dark.
- To disable the light sensor, push and hold the "Light Sensor" button for approximately 5 seconds until the "OFF" indicator appears on the display.
- To enable the light sensor, push and hold the "Light Sensor" button again for approximately 5 seconds until the "ON" indicator appears on the display.
Motion Sensor
- The clock is equipped with a motion sensor that will detect movement in front of the clock and activate the sound and motion sensors.
- To disable the motion sensor, push and hold the "Motion Sensor" button for approximately 5 seconds until the "OFF" indicator appears on the display.
- To enable the motion sensor, push and hold the "Motion Sensor" button again for approximately 5 seconds until the "ON" indicator appears on the display.
Nighttime Silencer
- The clock is equipped with a nighttime silencer that will automatically turn off the sound and motion sensors during a designated period of time.
- To set the nighttime silencer, push and hold the "Nighttime Silencer" button for approximately 5 seconds until the "SET" indicator appears on the display.
- Press the "Melody" button to select the start time for the nighttime silencer.
- Press the "Volume" button to select the end time for the nighttime silencer.
- Push the "Nighttime Silencer" button again to save the settings and exit the nighttime silencer mode.
Troubleshooting
- If the clock does not operate properly, try replacing the battery with a new one.
- If the clock still does not operate properly, contact Seiko Customer Service for assistance.
Note: This manual is for general information purposes only and may not cover all features and functions of the Seiko Melody in Motion Wall Clock, Model # QXM123BRH. Please refer to the manufacturer's instructions for complete information on how to operate and maintain your clock.
10/18/2023 1:00:12 AM •
Home
•
Answered
on Oct 18, 2023
Not finding what you are looking for?
