Brother DCP - Popular Questions, Answers, Tips & Manuals - Page 5
How to trouble shoot Machine Error 70 for DCP-J140W Printer.PLease help me.
Since I am working in the Techical Support department at Brother I can give you some little advice:
Machine Error 70 is a hardware fault of the machine, after the Service Manual it means:
"Cannot detect the ON/OFF state of cap lift cam Switch"
After the instruction in the service manual the service technician would have to change the whole maintenance unit of the machine.
You can try to clean the index stripe as described in faq00002918_004, but I doubt that it will solve the problem.
It looks as if you have to send in the machine for repair if it is still under warranty or replace it with another brother.
Best regards!
1/25/2015 10:35:39 AM •
Brother...
•
646 views • 1 helpful votes
MY BROTHER PRINTER 4F
Hi Anonymous.
The 4F error is related to a failed printhead.
In the case of this new printer coming up with a 4F error it can be one of two things.
1) The printer had a faulty printhead straight out of box. Not common but can happen.
2) You have pushed your printer too hard. Normally Brother Inkjet printers are not designed to handle 2000 page print jobs (That is 4 reams of paper) most inkjet printers don't even have close to enough ink to do this sort of print job. You may have just blown the printhead up through overuse.
I have a brothermfc 7340 printer and cannot replace the drum
Open the front of the printer by pulling the front panel toward you and down. (where you replace the toner cartridge)Remove the toner cartridge/drum unit assembly by pulling up and toward you.separate the drum unit from the toner cartridge by pressing the green release tab on the side and lifting them apart.place the toner cartridge into the new drum unitreplace back in the printerpress "clear/back" button and then press "1" to cancel "replace drum" messageclose the front panel.http://support.brother.com/g/b/faqend.aspx?c=au&lang=en&prod=mfc7340_us_as&faqid=faq00000154_039
Brother dcp 7040 prints and then prints too light
Before refilling, clean entire cartridge units. Remote its cleaning blade and clean it with an IP solutions and make sure no bends in cleaning blade. Do not mix new toner powder with old one. Also clean plastic portion below the developer roller also. Then the same complaint found, clean the LSU unit of the machine. Now it work properly.
How to Clear the Paper Jam Message from the Brother dcp-j315w Printer Display
At the back of the printer there is a door normally with a latch. You slide that as far as possible and open the door and can easily pull the jammed paper out. If that doesn't work open the front panel as how you open to replace the cardrige and you will see the jammed paper and gently pull it out.
hope it would help
1/6/2015 12:48:04 PM •
Brother...
•
448 views • 0 helpful votes
Not finding what you are looking for?