Brother DCP - Popular Questions, Answers, Tips & Manuals - Page 4
How to clear error 4f help please
When power on the printer listen that there must be a sound of motion motor and ink assembly in its carriage. If silence open the printer check motor belt and carriage belt. Replace the damaged and test.
10/25/2015 10:18:32 PM •
Brother...
•
130 views • 0 helpful votes
Toned ended brother 1510
System error 02:10
Explanation
A problem has occurred with the carriage assembly.
Recommended action
Turn the printer off and allow a few minutes for printer to cool. Turn the printer on and attempt to verify functionality.
If the problem persists, click on Support at the top of the page for additional HP support and contact options.
Brother 1510 replace toner problem
Assuming you have tried to replace an empty toner with a new or refilled toner cartridge. Some of these machine simply fail to recognise the reset activation lever on the side of the cartridge. You could try removing the end cap at the geared end. You will find a half moon shaped gear which needs to be lifted out slightly and rotated a quarter turn clockwise. replace any other gears and refit the cover. This resets the toner cartridge to "new" state. If you printer doesn't recognise this, you will need to get a manual reset keycode from brother. Please note - some folk reset used cartridges this way and re-use them. Used toner will contaminate the drum and give poor print. Any residual contaminated toner on the drum can contaminate a new cartridge and so-on. Refilled cartridges are fine if the cartridge is completely cleaned out first.
BROTHER DCP-7065DN HOW TO REPAIR LEFT SIDE VERY LIGHT PRINTING
When this occurs it usually means that the toner cartridge is running out of toner on that side. The left is most common since most printing is on that side. Remove the toner cartridge, and shake it vigorously from side to side for a few second, then replace and try again..
Unabel to print 72
This is a hardware issue, you may need to bring this into an authorised Brother service center for repair
3/25/2015 11:30:08 AM •
Brother...
•
448 views • 0 helpful votes
How to fix brother dcp J140 message unable to init 4f?
Error 4f means that your carete is damaged, probable after using not oryginal cartridges, it's reportable but to expensive. If you used brother ink, you can do an complaint I in brother service point.
2/16/2015 11:35:09 AM •
Brother...
•
1,228 views • 0 helpful votes
How do I reset dcp-8045d hex dump mode
Probably the easiest way to turn off the Hex Dump mode would be to reset all printer settings. There should be a reset menu that will allow you to reset the printer to factory defaults. After which it should recognize the new ram and print normally.
4/2/2015 6:15:53 PM •
Brother...
•
282 views • 0 helpful votes
Not finding what you are looking for?