Breville Juicers - Page 5 - Recent Questions, Troubleshooting & Support

If its a Brevill have you tried their spare parts section ??

Check the plug to the outlet first of all. If it is good do the next test.
The on switch will be needed to be checked. If you have an OHM METER you can check the continuity with that. All you do is take the probes and touch each electrical contact with the switch set to on and see if a reading of numbers show. If OL stays on the meter the switch is at fault. Yes the switch will have to come out to test this switch too

You could refer to http://www.brevilleusa.com/breville-parts/juicing.html if you're in the US.

Otherwise in Australia call 1300139798 and ask for details of your local Service Centre.

No good. You'll need to locate your local Breville service center.

Otherwise, refer to http://www.brevilleusa.com/breville-parts/juicing/juice-jug-je95xl59.html as you can order direct!

Remove the rubber legs to get to the screws onder them

First, turn off the power at the circuit breaker and look for a small reset button. There should be one. If not, leave the juicer on off - and turn the circuit brkr. back on, and try again. If this still doesn't work. Check and see if you're plugged into a GFI receptacle, which has a little reset button on it. In fact, you can check this first. Good Luck to you! Feel free to contact me again if this doesn't work for you. - Jim

you will have to contact the BREVILLE service center for the required parts.because the BREVILLE brand is not proving the parts online.you will have to personally contact the company and order the required parts from the company. How do I contact BREVILLE?
Toll Free Phone Number: 1-866-BREVILLE (1-866-273-8455) 8AM to 5PM PST
Email: [email protected] ------ for all the detailed help about the BREVILLE product please click on the link directly http://www.brevilleusa.com/support/faq.jsp
This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya

flip down the lever to pull it all apart.

rinse out the lid, food pusher and base(that the mesh filter sits in).

scrub out the mesh filter with a dish brush or the included brush if you have it. be carefull the grater-like parts at the base are very sharp. make sure it's clean by holding it up to the light. if there are any particles left clinging to the mesh it will seriously interfere with the effectiveness of your juicing.

you can line the pulp collecting jug with a plastic bag so that you dont have to clean that out as well.

it's best to clean everything immediately. if for some reason you can't, at least rinse the plastic parts and leave the mesh basket to soak until you can get back to it.

if you have any dried food or staining on any of the parts then a soak in water with lemon juice in it (maybe the juice of 3 or 4 lemons) should help soften up particles and strip away stains.

hope this helps....

:)

Ask them, they will get it for you.

if you happen to live in North America...Then you got Wal Mart..Tell those People to F!@#$%^Off and go buy a new one

go to my site and download the last entry in PDF format. I will be removing this link in a couple of days so be sure to save itl.

http://tricia8765.fatcow.com/HELPGUIDES.htm

This is the link that will bring you directly to your manual:

http://dl.owneriq.net/c/c917f4a7-2e69-40c4-9bbc-e00c4ba83628.pdf

If you would like, just highlight, copy and then paste the link in your internet address bar under a new tab.

Resolved by obtaining a manual to copy

yep, you pressed to hard while juicing something not ripe or very leafy