Bosch Dishwashers - Page 9 - Answered Questions & Fixed Issues

Check impeller in pump for foreign object

Most late dishwashers range between 40 and 50 dB. That is equivalent to the ambiant noise of a library room.

E24 error indicates draining failure and dishwasher not draining issue usually occurs due to kinked drain pipe, clogged drain filter or drain pump. First make sure that the drain is not clogged and remove clogs if present. Bosch Dish Washer Error 24 EASY FIX

Try cleaning the pressure chamber and sump hose, if not this , it is not heating ( heater or pcb)

E15 fault is water into base and has activated the anti flooding device. You will need to remove the water from base and investigate for leaks.

The symbol you're describing is saying the salt tank is empty. Normally on this model if the dispenser isn't opening it's because it's not heating, the dispenser is triggered when it reaches a set temperature

most bosch dishwashers have a filter that can be removed and cleaned at the bottom of the tub check filter to see if it is dirty. if the filter is clean make sure your water is hot enough min 120 degrees at faucet may want to run hot water at sink before starting dishwasher

When I start a new cycle, I first hear the pump run to empty out all remaining water, and after that I hear the motor run for the regular washing cycle, but there is no water in the dishwasher. After a few minutes, the cycle stops, and the washer claims the dishes are 'clean'. When I try starting a new cycle over and over again, about one in 20 times, the cycle will run normally with water. But then the next time, the problem starts all over again. Once a cycle starts correctly, everything works fine, including the rinsing.

Where can on my phone at?

Door lock is jammed on , take front panel and console panel off , with a screwdriver, flick door lock mechanism to open, spray with wdr0 and it should work

the unit could be un-level

Consult owner manual

Are there any error codes? Check that the drain line to the sink is not clogged. Check the air gap at the back of the sink. Pull up the chrome cap and unscrew the plastic cap underneath and make sure there's no blocage there. Undo a wire coat-hanger and run it down the hose to the sink / garbage disposal to unclog any stoppages. .

Why would we cover it. We’re not Bosch or anyone else responsible for your dishwasher. We’re fixya, a forum for asking repair related questions.

You placed this in cars and trucks category.

High explosives are my first response, always

If this item if free please find another forum to give it away even tho we are thankful.... have a great day https://www.6ya.com/mr.mike

Any fault code in the display?

The drying cycle pulls the most current. On most units there is a heating element in the bottom of the machine just like a stove has. Bosch does not use this technique, they have a built in heater in the water system that superheats the wash water. IT may be that nothing is wrong with your machine. When the unit was installed, there are wire nuts that are put on the supply wires in that unit and if they are not installed well, they can have an issue with overheating when the machine starts using a lot of current.

Six years is about the life of a dishwasher.