Belling Kitchen Ranges - Recent Questions, Troubleshooting & Support

Belling GT 755 Installation And User Instructions Manual

ManualsLib https://www.manualslib.com > ... > GT 755 View and Download Belling GT 755 installation and user instructions manual online. Slot-in Natural Gas Double Cavity Cooker. GT 755 kitchen appliances pdf ...

Product Manuals & Technical Specifications

Belling UK https://www.belling.co.uk > en-gb > manuals Looking for user manuals, product specifications or cooking guides? Take a look at our entire collection of sources or contact our Customer Care team on . ..

It could be. I suggest you get the assistance of a caravan club member who knows about gas cookers to help you.

For that type access is normally by removing screws at the side. Belling CFE60MFTC https://www.google.com/search?q=Belling+cfe60mftc+replace+oven+control+Knob ..

Question edited for clarity. Question moved from Kensington Computer category to Belling Kitchen Ranges. 'Access' in "how do I unlock it and press the buttons", or "how do I take is apart"? There is some help in the link, or reach out to Belling Customer Care. https://www.google.com/search?q=Belling+kensington+100e%2C+access+control+panel ..

I'll give this a go! With a cooker like this, you depress and then turn the control knob, press the ignition button and continue to depress the control knob for a few seconds. This is because a device called a thermocouple is heated by the flame and you have to continue to depress the control knob so that sufficient gas flows to heat up the thermocouple. If the thermocouple does not get hot or stay hot then the gas valve is automatically closed - stopping the gas. The thermocouple is a 'flame failure' safety device. If the gas gets cut off then the flame goes out and the thermocouple goes cold switching off the gas valve automatically. However, you are having to try and manually keep the gas going for a good five minutes. I would think that there is either a problem with the thermocouple or the gas control valve! Tony www.birminghamelectricsltd.com

Taking a guess, I would expect gas is leaking from somewhere and bypassing the burner and when it has built enough to reach the flame it will pop. LPG is heavier than air... I suggest you remove the burner and ensure everything is clean including inside the mixing chamber is free of fluff and dust and ensure the gas jet and gas supply to the jet housing is tight and the connection to the pilot light is similarly tight.

Pull the cooker out and look

if diy. turn off power, remove plug from socket. remove access plate or back where cable enters and observe internals . Ascertain if there is are fuses were cable attaches. if nine leave and contact electrical repairs or supplier. remember if you remove or undue screws, you void any guarantee remaining.

, push in and turn the control knob to the full on position (large flame symbol). If your hob has an ignition switch on the facia, press it in until your burner lights. • Hold the control knob in for 15 seconds then release. If the burner fails to light within this time, release the control knob and wait one minute before attempting to re-ignite. or Push in the control knob and after a couple of seconds press the ignition switch. • Hold the control knob in for 15 seconds then turn to desired heat, If the burner fails to light within this time, release the control knob and wait one minute before attempting to re-ignite.

The oven has a flame detection installed that makes sure the gas turns off if the flame goes out. There are two component that do this. One is the flame detector and the other is the control device that turns the gas off,. Either one of these cold be faulty. The cheapest way is probably to replace the detector in the oven and if that does not work, replace the gas control device.