American Standard Heating & Cooling - Page 2 - Recent Questions, Troubleshooting & Support

What relay does he click?

I'm seeing 22 as a loss of flame. Unfamiliar with gas and oil, I'm in south Florida. Does say it locks out for 1 hr and will retry, possibly cycling power will reset lockout but unlikely to fix problem. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Does it cool when in heat? Is this a heat pump? What's supply air temp vs. return air temp? Outdoor unit running? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

The number of flashes indicate a fault there is a code on the door panel

low pressure error If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

You should look at your furnace and see if any safety lights are flashing. Make sure your thermostat is set to heat.Check system your using for updates.

I see so many problems with these. make sure your thermostat is set to heat. if its hard wired simply turning it to the degrees it shows a bit past, should turn it on.If not check the heat source for any blinking lights which means a malfunction on the heaters it self... If you checked fuse box sometimes to flick the switch to off and back on does the trick to reset it.

Wow, you are going to have a heck of a time finding that. Try contacting American Standard. They may be able to help you.

http://myfurnace.net/american-standard/manuals-specifications-literature

what model number. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

123 I believe is a configuration error. touch the error on the screen and see what it details. let us know. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

likely a tripped float switch. need to vacuum drain and clear the float switch. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

All you need to know is that it is a 1/4 hp, 825 rpm. 1/2 inch shaft. That is if you are going to buy an after market motor. I have had to make new mounting holes when using after market motors on trane systems (just the way trane is) but not a problem. If you're getting it from trane you would only need the model number of the condenser. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

114 is a communication error in the air handler. It can be the afc board, the blower motor or both. Cycle power to the AHU by the breaker. Leave off for about 10 seconds. If error comes back you will likely, at least need an afc board. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79