Alpine Car Audio & Video - Page 5 - Popular Questions, Answers, Tips & Manuals

need more info please..

What gauge wire are you running from the battery to run your Alpine amp? If the amp isn't able to draw enough current to drive your subs, it will not function properly. It could possibly damage your gear. Also check that your battery and alternator are up to the task. Car audio will load up the charging system in a vehicle if it's low powered. You may need to upgrade your alternator and battery.

Here's Alpine's support site - https://alpine-usa.com/support Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/keith_f374b1cfd1696a17

First, take a good size battery ( I like using "C" size for a good volt) - take to wire and place on positive and one on the negative end. Once wires are attached, place one wire on the positive terminal on the speaker and the negative terminal - and listen for any sound. If you get sound (scratching sound) - your speakers are good. If this is the case. retrace your input/output connections. Also check the all devices are well grounded. GL

See page 13 in the manual and make sure BBE is the same across all modes (sources)

Is the amp in protect mode? Maybe a red light on the amp. I would also open the amp and check the RCA connections aren't loose. It's usually a solder joint. Swap the amp out as well. Or check your power wire. Sometimes amps come on when it gets remote power, but actually the power wire has a bad fuse or connection. I’m happy to help further over the phone at https://www.6ya.com/expert/chris_7f7f91eb941fb23f

Car stereos need a contant 12v power supply to retain memory for tuning and audio settings. It will be the yellow wire on the power harness to the back of your head unit.

Honda radio codes for a small fee from this link: Car radio codes in Uxbridge London Gumtree

Try holding down the set up button for 2-3 seconds. Press Dn or Up to select the subwoofer mode and the band button activate/deactivate SW function.

Is it possible that you may have over driven the unit and blown either the power supply or output stages? Well, if the amp is getting power as you indicate the issue lies within the stages I just mentioned.

Put another known working speaker in there to see if it works. If it does then the issue is with your speaker. If it also does not work your amp is to blame.

Only if designed to operate on 120 volts AC.

As last resort you might try a firmware upgrade if available. Otherwise the unit needs to be replaced since laser mechanism has lost the ability to focus on and play back cd's. Repair not cost effective so ..............

Your question is lacking some detail , is this a stock radio , after market , and what brand and model . Pictures can help , depending on the siuation code be s radio key is needed or if it's after market do you have a remote ? Try to change stuff with that , could be buttons inop or worst case it's just done. Good luck

Hello! Here is the link to the manual. Hopefully it will help you resolve this problem asap. Conector de entrada del altavoz Alpine MRP M500 12 16

Try eBay: http://www.ebay.com/bhp/alpine-ipod-cable or Amazon for specific cables

try the alpine web page for audio -parts

2 - You've burned songs in a different format than required by your car player 1 - you'd be able to do it through BT if your car has this feature. Just pair them

What is the code of bontec alpine a06012 car stereo