AEG Microwave Ovens - Recent Questions, Troubleshooting & Support

I have figured it out! what you do is hold the auto defrost button for about 3 seconds. A tone should sound. It will then show demo then off.

The thermal cut out switch needs re setting Unplug the machine . Remove the 6 screws from the top of the machine and remove the top cover . the thermal cut out switch is located on top of the heat exchanger which is a large brass cylinder in the middle of the machine as you look down. The thermal cut out is round black plastic with two electrical plugs on top towards the front of the heat exchanger. there is a button on top of the cutout which can be pressed. If the button clicks then that was your problem.

Power Failure, Demo Appears On Display And It Won'T Heat Up

https://www.aeg.co.uk > Support > Ovens Dec 10, 2021 - 1. Switch on device and select "basic settings" using · 2. Select "demo mode" · 3. Select "off" and enter code "2468" using the up and down arrows. Missing: MBE2658SE ‎' Must include: MBE2658SE

• Turning AEG Command Wheel Oven Demo Mode On and Off ...

  https://www.aeg.co.uk > Support > Ovens Jun 2, 2020 - Demo mode allows live appliances to be demonstrated in store safely without heating up and becoming a safety risk. If you need to turn demo ...

Wait for Parents to return. Do not panic. If building starts to burn reasess life choices

try to change your magnetron could be shorted or change your diode

http://kitchen.manualsonline.com/manuals/mfg/aeg/bp5003021.html Type in your model # in the search bar :-)

-Base on my experience. These days microwaves are cheap. I Prefer to buy new one instead buy replacement parts , end up 30-50 dollars but it still not work properly. -Good luck Mai

emerson mecrowave mw81195bm clock works but I can heat anything it doesn.t work inside

If you wish to get some details; check the site linked here. Pull up older posts...... http://electro-medical.blogspot.com/

If you wish to get some details; check the site linked here. Pull up older posts..... http://electro-medical.blogspot.com/

See the picture below: Dado

There is no microwave, so I suggest to check all HV components (magnetron, HV reactifier diode, HV fuse or protect diode, HV capacitor and eventually transformer). Dado

There is no separate fuse only for turntable motor. Usually there is two fuse, one in High Voltage section (instead fuse could be HV protect diode) and another one for 220 V (light, turntable motor, fun motor, display....). If light work normally then is turtable motor faulty. Dado

Condensation inside the oven comes mainly when the temperature is below 100 Celsius, and this phenomenon is evident in almost all manufacturers. That means, the condensation starts at the beginning and at end of baking. My advice is the same as many manufacturers recommend: Before baking, preheat the oven to min. 100 Celsius and after that place the food in the oven. Reverse the procedure in the "cool down" phase before the temperature drops below 100 ° C and remove the food from the oven.After that condensation should be drastically reduced.Condensation could be technically solved but it would be too expensive for manufacturers (more parts inside oven) as well as for customers also (too expensive appliance and lost energy).DadoPS. This applies to the traditional way of baking