AEG Dishwashers - Page 2 - Recent Questions, Troubleshooting & Support

Took unit apart and when I put it back it worked again. For how long who knows.

Access to the switch is difficult but by removing the printed circuit board, it seemed to allow the switch to work.

Google or request from manufacturer

I guess you got the alarm AL 6 on your display what means failure to drain. A control procedure has been added to all the final drain phases in order to check the status of the pressure switch. The contact must be open in the "empty" position in order to ensure that the cycle is performed correctly. If the contact is closed, the drain phase is repeated. At the end of the second drain phase, if the pressure switch contact remains closed, "AL" alarm condition is generated. Could be following:

• Domestic drain circuit not suitable (obstructed / blocked)

• Drain pump jammed

• Pressure switch faulty

• Sump - pressure switch tube obstructed

• Filters / drain hose obstructed

• Relay or Triac faulty

Down under is from AEG Favorit 86460 user manual, page 30 : ...a flashing fault code appears an audible signal informs you that an alarm has been activated, in the display appears one of the following flashing alarms: AL1 - AL2 - AL3 - AL4 - AL5 - AL6 - AL7, AL8 and the indicator light of the phase under way is flashing. They are indicative of a fault in the dishwasher that you can probably rectify yourself. - press the On/Off push button to switch the dishwasher off - open the door and carry out the following suggested corrective actions. Dado

https://youtu.be/96x4TUUyeJ4 Try this buddy

check the sum pump drian valve make sure it not cog up with tash because if it block can cause the drain pump to ruin ok

Owner's manual should have a troubleshooting section. Canal? you may have a serious leak in fill piping or control valves. or drain system. No owner's manual? Try MFG website or http://www.manualsonline.com/

Is it not hide in the big pumphose?

Online. I found two different places. http://shop.aeg.co.uk/category/Dishwashers/Dishwashers

https://www.manualslib.com/products/Aeg-Ko-Favorit-5270-Vi-3118379.html

If you open a sidepanel and look at the bottom of the machine you see a brown device with a piece of white foam,this is the leak prevention system.
Push foam down and the error code should be cleared.
Make sure you there's no water left on the bottom of machine

This seems like the anti flood system (polystireen float / micro switch) at the base of the washer is triggered,\. This puts the washer in pump out mode and stops inlet of water via the inlet solinoid. Dry the water on the base and then check for any water leaks. (pipe leak

Problems with a pressure sensor in your case.

Make sure your not putting tall items next to the little box that the tablet goes into. Sometimes they catch the door and don't come out properly

15-26yrs?

Do you know what is error i10 ? I have same