Questions & Answers for: yukon wheel bearing

...Yukon while driving ,then my yukons engine shut off and it pulled real hard to the left.Brake fluid level is good,brake pads and rotors are good. Your ABS sensor in the front left wheel is bad, this ...

front wheel bearing what is the recommended tourque for the axle nut on the front wheel bearing 2003 yukon denali AWD 156 ft lbs

...until slop or wobble is gone. Tighten the hub/rotor bearing nut to 16 Nm (12 ft. lbs.), while turning the wheel forward by hand. This will seat the bearings. 1999 GMC Truck C Yukon 2WD V8-5.7L VIN ...

...wheel bearings on my 2003 gmc yukon xl be serviced? or do they need to be replaced? from my experience I would replace them rather than trying to service the old ones, I had one fail completely after ...

...Yukon a grinding sound and feel just started on drivers side front while driving and it's deffinately not the brake rotor. If its not the brakes then it could be a wheel bearing. Jack it up and spin ...

...yukon denali has a whining noise similar to bad wheel bearings. wheel bearings were just replaced. could it be cv's, no clunking sound though. also, sometimes the vehicle ''jerks'' when accelerating, ...

...wheel bearing is out, how easy to repair Passenger side rear wheel bearing is out, how easy to repair yourself? 2002 GMC quad-steer all wheel drive Denali pick-up not easy,you will probably need a ...

...wheel of my GMC yukon now the ABS warning light and signal comes on and stays on,how do i make it go away? Double check to make sure the abs harness from the new wheel bearing is plugged in. If it is ...

...Yukon wheel bearing assembly with Timkin SP450301 , But the center of the new bearing is not snug into the center hole of steering spindel . Is this OK as long as the three bolts line up and screw in ...

...wheel bearing. E replaced without the hub on 2005 Yukon Denali No , it's a sealed unit . Hub bearing doesn't cost that much . Wheel bearing assembly replacement 2005 GMC Yukon Denali install