...yellow starts streaking all over the page and onto other pages. The fuser is low life and does need to be replaced, but I am not sure if this problem is being caused by the fuser. If it's going to ...
Question about Phaser 6250DP Laser Printer
...and usually done every 15-20k pages. Cost is about $250-300 and very easily replaced, fast as changing a toner. I am assuming that you tried changing the yellow toner already? If not, do that
...pages were clean, then the yellow got more and more pronounced for the next 10 pages or so, and then it began to gradually fade. Have never had any problems like this before -- You have a bad yellow ...
...pages are printed out or when the pixel counts are exceeded. A fuse in the new imaging unit will blow upon installation, resetting the counter. Verify color calibration. Clean lenses. Xerox Part ...
Question about Tektronix Phaser 7700GX Laser Printer
Phaser 7700GX getting yellow bar down the side of page on all prints Try cleaning the Laser Unit for Yellow. Try replacing the Imaging Unit for Yellow, or simply take it out and move it to another ...
...pages: Total Previous Colorant Usage Cyan=37.54 Magenta=36.35 (Yellow & Black had very minor changes) Printed Total Pixels Cyan=1,784,693 Magenta=1,773,124 AFTER 30 Cyan pages: Total Previous ...
Question about Phaser 7300DN Laser Printer
Phaser 7300 dn prints full yellow color background on every page even if the background copy shows no color. Most likely the yellow drum unit is causing that problem. The charge roller gets worn and ...
pages, if it continues to dump yellow toner then it is probably a bad developer. If it changes to cyan then it is a bad image unit. If you need another image unit the part# is 108R00581, you can buy a
yellow band on page about 3/4 down page has a yellow band (see through)about 2in wide the good print have replaced toner and pc unit still there It is probably the yellow Image Unit (the toner fits ...
...in other OS) Create a full page of cyan, and print about 100 - 200 pages, or until the cyan starts to clear up. Yes it is a waste, but much cheaper than a print head, Do this for yellow as
Usually answered in minutes!
534 Questions
436 Questions
284 Questions
267 Questions
262 Questions