Questions & Answers for: Pontiac wiring for pump

Question about 2000 Grand Am GT

1 Answer

2000 grand am 3.4 fuel pump wires Try to force fuel pump on. I know gray wire is power but need to know what are the other wires are in order to turn pump on.. Pump / relay and theft sytem are good ...

Ad

Question about 2005 Grand Prix

1 Answer

Fuel Pump Not Getting Power Is there an emergency fuel cut off switch on a 3800 series III? I can hot wire the pump from the relay and get the pump to start when turning the key, but it will not start

Ad

Question about 2005 Grand Prix

1 Answer

1995 pontiac firebird ,I replaced fuel pump ,fuel pump relay ,the only way i can get fuel pump to run is unplug relay put jumper wire across terminals from red to gray wire,then i have good fuel ...

...only a couple secs once key is turned on. none showing and no power to the gas gauge. GM Fuel Pump Relay Testing How to test an electric fuel pump http://www.bbbind.com/free-tsb free wiring ...

Question about 1994 Grand Prix

1 Answer

...is the cause for the short. Other than that, check where the wires go from the fuel pump wiring harness to the connection to where they go back inside the car. Corrosion is often another

Question about 1994 Grand Prix

1 Answer

...wiring harness.jumper a wire from the battery to this wire and the fuel pump should work or make a noise this is a direct feed power wire to the fuel pump for this purpose,you also could have a bad ...

Question about 2002 Grand Am

2 Answers

...pump wiring in the harness that goes to the pump. Check the wiring that goes to the pump near the tank and look for chaffing or corrosion in the connector. Also check that the grounding of the fuel ...

Question about 1994 Grand Am

1 Answer

fuel pump relay I'm having a problem with the red fuel pump prime relay. every thing else works fine on the car but i can not get the power to the red wire going to it. it goes to the fuel pump ...

wires to air pump has no power. all others are ok. I tested the wires for the air pump and I have no power, all other wires controlling other functions have power. need help please!!!!!! air pump with

...wiring back at the pump. There's a bulkhead where the wires come back to the pump and sending unit then a section of harness goes to the pump and sending unit. I'm trying to figure out why I have ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...