Questions & Answers for: Flotec wiring for pump

...wiring Flotec sprinkler pump The pump is wired for 220. Does it matter which wire is on which terminal. The terminals are labeled L1 and L2. I've seen in other posts that it should be Black to L1 and ...

flotech utility pump clogged. took top off and flotech utility pump clogged. took top off and there are 3 wires i'm not sure where to go. 2 wires are black and one is green. there are 3 posts does it ...

flotec 1/2 hp pump won't run. 124v line voltage. But L1 to L2 shows -00.1 to -00.4 Power supply line is 12/2 to a on/off switch and 14/2 to pump from switch. Distance to service is less than 100 feet ...

...wiring where the new pump wires connect to my old wires with a bad heat shrink wrap, if so would it have worked for the last four months? I have already bought a new pump if all else fails, but I can ...

my pump is wired for 120 and the diagram shows that a black trace wire to terminal B and a black wire to terminal A.Know my problem is the way its hooked up is a black wire on A and a black and white ...

...if you leave the circuit as 115VAC. John if only 120 volt check side of motor for low voltage ...

...pump did not overheat in the short time it was on. Before I do anything else I'd like some advice. Flotec customer service was no help and said others have called with the same issue but they ...

pump safety switch wiring from pump to switch hooked up wrong The wiring information is in the manual. Are you calling the pressure switch a safety switch?

how do I wire controller box wire submersible pump? How do I wire controller box for 3 wire submersible well pump? How do I test the pump directly? Is it 110VAc or 220Vac?

Worked nicely for 2 years. Following long deep freeze, motor does not respond to float switch. I don't hear or feel any click when I lift the float. Not sure what the problem is but one should never ...