Questions & Answers for: wiring ecu pins

...Pins 5 and 6 (wire colors brown and red/blue respectively) of the MAF connector are for the air temp sensor; Pin 6 is the 5V reference voltage from the ecu, pin 5 is the return signal (ecu

how do I wire a remote door lock to my 1995 mitsubishi eclipse , what are the wire colors for the power door locks? Hope this helps. It's for a 2004 eclipse remote start. 12volts white/red (40A) + ...

headlamps inoperative daytime running lamps come on then go out jumped out headlamp switch ground circuit out still no headlamps. It sounds like your DRL RELAY/Headlight relay. I had this happen with ...

...ECU and all injectors. this is 12v key on. if not check all coil pins on main. i answered in the generic and exact. old post. but lots of old handa's still , all this is on alldata.com or at

...wiring stuff (evil) http://www.fixkick.com/ECU/5vdc-Refr-supply/56B30-5VDC.jpg the acutal blown trace (and zener blown too) is here see it, (if real sammi, it will be i different loc.) this is a ...

...cut (either) or ecu is blown.
re-seat the ecu yet? inspect those exact pins for corrossion at ECU end?
there are many tests here, not just a noid.
use a voltmeter.
or a scope, 10x

what controls the ground for the injectors on a 1992 toyota celica. I have sent out the computer and they sent it back saying it was ok. I have power to the injectors but no ground on # 1 & 3. Help ...

ecu pin out 2mz-fe auto...toyota windom... [PDF]WIRING DIAGRAM BY MODEL - Apexi www.apexi-usa.com/manuals/electronics/neo_diagram.pdf TOYOTA. Table of Applicable Models. ..... The orientation of the ...

check wiring,, check 12vd on both injector power pins if wiring is ok check for ecu pin at ecu that drives injector 3 and 4 called the pNp pin if dead ecu is toast. (if injector coils read good.. ohms

...wiring of the ECU ZEXEL 8pe1 engine? Where is the wiring pin out of ECU in 8pe1 engine? If it is available for free it is here. The website Scribd has it for cost. ...