...code. Work backwards until you locate the break. Turn the key OFF. Unplug the the connector from the servo and measure the servo coil resistances. measure the resistance between the servo pin that ...
Question about 1999 Grand Voyager
...window resolved "spontaneously". Codes 1698 and 732. you need to go over your entire wiring harness, under the hood and inside the dash. Start with the ground wire on the battery and ...
Question about 1996 Breeze
i changed plugs and wires got a oil change.. but my car still shuts off sumtimes what should i do it shuts off while driving starts rite back up sometimes and my engine lite comes on and off. i ...
...code p1698 check engine light on The manual for the codes p1698 suggests that using the diagnostic readout box that you remove the plugs at the tcm and the pcm then by jumper ground the bus + and the ...
...wiring problems, and the code keeps returning with the IAC unplugged, you can check the PCM by removing the IAC wires from the PCM connector (or clipping the wires in a location where they can be ...
...code and see if it comes back. Next, check all wiring and connectors that lead to the speed sensor. The location of the sensor depends on your vehicle. The sensor could be on the rear axle, ...
the abs ligth is on in a plymount grandvoyager 98 You must have the car scanned for codes with an ABS capable scanner. The code will tell you what's wrong, usually one of the wheel speed sensors. ...
...code but doesn't rule out the possibility of one of the other causes * Open in the wiring to the injector * Short in the wiring to the injector * Bad PCM Check and test this possible solutions: ...
Question about 2000 Neon
...code up as well ,this is really a repair shop job as would need to get under vehicle to inspect some of the wiring etc Try this link http://www.xtremeneons.com/how-tos/engineandtrans/2kcodes.html it ...
Question about 2000 Neon
...wiring. Both of the codes refer to the same problem. The TCM (transmission control module) set the 0715, and it communicates with the main computer which set the 0700 code. a good sign they are ...
Usually answered in minutes!
758 Questions
706 Questions
609 Questions
602 Questions
526 Questions