Questions & Answers for: how to wire turn signals

...wire that comes off the left turn signal harness. Next follow that wire the entire way back to the firewall looking for another wire fused to that wire as you go. If there are no signs of this you ...

...wire unit has a turn signal and a running light in it. Remove the turn signal lense and you'll probably see a dual filament bulb. The two wire system is shown as an "International" wired model ...

...turn signal to heavier black electric wire coming from under headlamp. To switch out turn signal post for new one, do I cut wires close to solder points, strip wires, and re-solder wires to new turn ...

...turn signals. There should be two grey wires with a brown ring on one wire and a violet ring on the other. Trace these wires out and check for sorts or open circuits. Maybe the plug came unplugged. ...

turn signal wire to the bike's wiring that is 'hot' with the turn signal switch on. Plug the running light wire from the turn signal into the bike's wiring that is 'hot' whever the key is on. Hook the

turn signal wire is for the running light. It is possible that a replacement turn signal may not have the same wire colors as the original. You can use the turn signals on either side of the bike. The

...wire to the turn signal body to make sure it's got a good ground. Now, there is the possibility that the turn signal will not work at all. Your bike is equipped with the automatic turn signal ...

...turn signal bulbs needs to be inspected, there is any of the wire that is confirm getting short with metal body or its got loose, that is causing the problem.---------The wire connecting to it are ...

wire goes from turn switch to rear light, while the turning signal wire will go through the flasher relay, and then to the rear light to cause blinking. I hope that makes sense. It appears the problem

...wire on either should be for turn signal. With everything turned on, is there voltage on that wire? Because the front works and the rear don't, possible wiring circuit problem? The voltage for turn ...