Questions & Answers for: wire nuts

Question about PHH15002 Oil Filled Baseboard Heater

1 Answer

...trying to connect the thermostat to the baseboard heater and the power supply. I see 2 black wires with a crimped wire nut and 2 with a regular wire nut. not sure i understand the instuctions. ...

Ad

Question about 10AJA2501AH Air Conditioner

2 Answers

...wire nuts, this is where you will attach the wires back to. One wire to each wire nut. There should already be a wire in each nut that goes on into the ac unit. You will remove the wire nut and twist ...

Ad

Question about Decora Light Dimmer Switch

1 Answer

...wire nuts, remove the wire nuts and take a look. If they are messy, cut off the exposed ends of all of the wires and re-strip them. Stranded wires are difficult to strip well without a wire stripping ...

Question about Decora Light Dimmer Switch

1 Answer

...wire nuts? Hi. Yes it is possible to connect the wires with wire nuts. (Without tape! / tape can melt) You must use ceramic / porcelain wire nuts (white) in HOT areas. Make sure it is a clean ...

...wire connectors. Remove nuts from harness holddown, battery terminal, ground terminal and 2 field terminals. Remove wire connectors. A typical generator wiring harness is shown in. Wiring harness ...

Question about Inc. ST01C Digital In-Wall Timer

1 Answer

wire nuts included with timer. Put two wires together so they are even at ends. Put wire nut over wire ends. Rotate wire nut clockwise between fingers until very tight. 2) Switch has 2 insulated wires

Question about Inc. ST01C Digital In-Wall Timer

1 Answer

...wire nuts? If so, how are these white plastic caps removed? They're called "wire nuts". Turn them counterclockwise to remove, lay the wires you need to join side by side with the ends of the bared ...

Question about Inc. ST01C Digital In-Wall Timer

1 Answer

...wire nuts covering black wire and white wire, and possibly another wire nut covering green wire or bare copper.Untwist wire nuts. Attach new light fixture wires same way as old was removed.Make sure ...

Was puting new positive wire on starter that goes to battery, nut came off easy,put new wire on started tighting nut back on and whole stud is spinning,starter is still on truck 1978 chevy 350 v8 c10,

wire nuts (small), twist the two ends together and screw on the wire nut. 3. Do the same thing to the other wire. Now take black electrical tape and tape each wire nut down the wire about 1/2 inch. 4.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

Paul Carew

Level 3 Expert

3808 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Heating & Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...