Questions & Answers for: Pontiac Montana wiper arm

...wiper arm The wiper arm out through the opening in the wiper blade To Install: Install or connect the following: The hook of the wiper arm through the wiper blade opening The wiper blade pivot into ...

...arm on the wiper motor. There is a bracket under the crank arm that has a small upward part on it that the bottom of the crank arm is supposed to stop on when its shut off. Put the wiper in the pulse ...

...wiper arm and re-position arm to correct stowed position. Re-tighten any wiper arm attachment nuts/screws etc. Check wiper attachment arm for damage or cracks at the spigot mount. Replace if

...on in the position where they should normally sit when shut off. My concern is that the posts they attach to may have the splines stripped off them , or the wiper arm itself might be stripped

...the crank arm assembly as they are prone to wear. Check all the parts on the wiper transmission for siezed pivots and bent arms. I hope this helps you towards a repair. Thank you for using FixYa. ...

...wiper arm/ motor assembly MOVES in a circular motion. Use care when exposing this assembly. If your wipers don't park or if they stay in the up position when in the delay mode, you probably have to ...

...wiper arms down and watch that the small outer connector arm rotates in a full circle. Have a friend grease(white) or oil with machine oil these connectors. if they move but don't fully rotate, ...

...arm on the wiper motor.Rotate the washer solvent container into the installation position.Install the washer solvent container screws. Tighten Tighten the washer solvent container screws to 6 N.m (53 ...

...wiper arm has nut I guess it is 17mm .take off the small cover and then loose the nut,pull out the wiper arm while it is in upright position put back the wiper arm to the desired position and tighten ...

the nuts on wiper arm move but doesn't. Is there a part that I can replace without replacing entire assembly? Just replace the wiper arm. Remove the nut and check the the splines on the shaft are okay