...(one for each wiper arm). If you can't find it, you'll have to change the part out on the new motor. Keep the wiper arms in the same location on removal, or it will jam and you'll have to start
...wiper arm and turn the blade so that is faces away from the windshield. I can't get the wiper arm to lift up far enough so that there is room to swivel the blade. Please help. I need to leave on a ...
how do the wiper arms come off a 2007 GMC Yukon? I just see a round button where the nut should be. I think you will find the nut under that button,get in there and dig that button out!
Need to remove the wiper arms to replace a cracked cowl. Need to remove the wiper arms to replace a cracked cowl on a 2005 GMC Yukon. How do they come off? on most g.m. products they're on a spline ...
...wiper arm seems to be making poor contact with the windshield. Is there an adjustment? All you have to do is .... slighty bend the arm inward, and you should be fine...Not too much, then it will have ...
with the windshield wipers on a 2007 gmc yukon are you supposed to replace just the blade most all you can buy now is the whole arm autozone or oreilys will replace these when you buy them at no ...
...wiper transmission and a support bracket and remove the tranmission/motor assembly. -Remove the connector plug, be careful not to break it. -You then have to separate the drive link arm from the ...
...arm. Remove wiper motor crank arm brackets. Remove three bolts and windshield wiper motor from vehicle. To Install: Install windshield wiper motor and three bolts. Torque to: 62 in lbs. (7 Nm) With ...
...is this a switch problem If it makes noise when you turn it on, the switch is working. So whats making the noise. If you replaced the motor, there isnt much else. Is the wiper arm tight on the
Usually answered in minutes!
593 Questions
524 Questions
309 Questions
326 Questions
238 Questions